Dtmf Autodialer Operation - Yaesu FT-7900R Operating Manual

DTMF A
Sixteen DTMF Autodialer memories are available on the FT-7900R. These DTMF Autodialer
memories can store up to 16 digits of a telephone number for repeater autopatch or other
uses.
To load DTMF Autodialer memories, use following procedure:
1. Press and hold in the [ BAND ( SET )] key for 1/2 second to enter the Set mode.
2. Rotate the DIAL knob to select Menu #14 (DT WRT
3. Press the [ BAND ( SET )] key momentarily, then rotate
the DIAL knob to select the DTMF Autodialer memory
channel number ("d-1
wish store a telephone number.
4. Press the [ BAND ( SET )] key momentarily, then rotate
the DIAL knob to select the first digit of the telephone
number you wish to store.
5. When you have selected the correct digit, press the
[ BAND ( SET )] key momentarily. Now, rotate the DIAL
knob to select the second of the 16 available numbers in
this current DTMF Audodialer memory register.
6. Repeat this procedure for each digit in the telephone number. Press the [ SCAN ( SEL )]
key momentarily to delete any previously-stored data
after the cursor. If you make a mistake, press the
microphone's [ DWN ] key to move back to the first digit,
then re-enter the correct number.
7. When entry of all digits is complete, press and hold in
the [ BAND ( SET )] key for 1/2 second to save the new
setting.
8. If you wish to store another DTMF string, rotate the
DIAL knob to select another DTMF memory register,
then repeat steps 4 through 7 above.
9. When all required DTMF memories are filled to your satisfaction, press and hold in the
[ BAND ( SET )] key for 1/2 second to exit to normal operation.
56
UTODIALER
d-1" through "d-16 d-16") into which you
d-1 d-1 d-1 d-16 d-16 d-16
O
PERATION
DT WRT). DT WRT DT WRT DT WRT
FT-7900R O M
PERATING ANUAL