Storing Independent Transmit Frequencies ("Odd Splits") - Yaesu FT-7900R Operating Manual

M
EMORY
R
EGULAR

Storing Independent Transmit Frequencies ("Odd Splits")

1. Store the receiving frequency using the method already described.
2. Turn to the desired transmit frequency, then press and hold in the [ V/M ( MW )] key for
1/2 second.
3. Within ten seconds of pressing the [ V/M ( MW )] key, use the DIAL knob or microphone's
[ UP ] / [ DWN ] buttons to select the same memory channel number as used in step 1 above.
4. Press and hold in the PTT switch, then pressing and holding the [ V/M ( MW )] key for
1/2 second while holding the PTT switch to save the entry and exit to normal operation.
This will not cause transmission; instead, it signals the microprocessor that a separate
transmit frequency is being programmed into that memory register.
Whenever you recall a memory which contains indepen-
dently-stored transmit and receive frequencies, the "
indication will appear in the display.
If you set the CTCSS/DCS functions to the receiver frequency and transmit frequency indi-
vidually, the "Odd Splits" feature can be memorize the frequency/code individually for trans-
mit and receive.
Whenever you recall a memory which contains indepen-
dently-stored CTCSS/DCS functions, the decoder icon will
appear and the encoder icon will blink in the display.
To confirm the memorized frequency/code:
1. Press and hold in the [ BAND ( SET )] key for 1/2 second to enter the Set mode.
2. Rotate the DIAL knob to select Menu #9 (DCS.COD
when the receiver CTCSS/DCS function is set to "DCS",
or select Menu #44 (TN FRQ
DCS function is set to "TONE SQUELCH".
3. Press the [ BAND ( SET )] key momentarily to display the
memorized frequency/code for the receiver.
4. Press and hold in the [ TONE ( HM/RV )] key for 1/2 sec-
ond to display the memorized frequency/code for the
transmitter. You can confirm the Transmit and Receive
TONE/DCS by alternately press and holding of the
[ TONE ( HM/RV )] key.
5. Press and hold in the [ BAND ( SET )] key for 1/2 second to exit to normal operation.
34
O
PERATION
M
EMORY
TN FRQ) when the receiver CTCSS/
TN FRQ TN FRQ
TN FRQ
C O
HANNEL PERATION
"
DCS.COD) DCS.COD DCS.COD DCS.COD
FT-7900R O
: Receive TONE/DCS
: Transmit TONE/DCS
M
PERATING ANUAL