Scan-Resume Option - Yaesu FT-2900R Operating Manual

Three scan-resume modes are available on the FT-2900R:
In the "BUSY BUSY" mode, the scanner will remain halted for as long as there is carrier present
BUSY BUSY BUSY
on the channel; after the carrier drops at the end of the other station's transmission,
scanning will resume.
In the "HOLD HOLD" mode, the scanner will halt on a signal it encounters. It will not restart
HOLD HOLD
HOLD
automatically; you must manually re-initiate scanning if you wish to resume.
In the "3SEC
3SEC 3SEC 3SEC/5SEC 3SEC 5SEC/10SEC 5SEC 5SEC 5SEC
after which scanning will resume (whether or not the other station is still transmitting).
The default scan-stop mode is "BUSY
procedure:
1. Press and hold in the [ MHz ( SET )] key for one second, then
rotate the DIAL knob to select "41 RESUME
2. Press the [ MHz ( SET )] key, then rotate the DIAL knob to
select the desired scan-resume mode.
3. Press and hold in the [ MHz ( SET )] key for one second to
save the new setting and exit to normal operation.
FT-2900R O
PERATING
S -R
CAN ESUME
10SEC" mode, the scanner will halt for the selected resume time,
10SEC 10SEC 10SEC
BUSY." To change the scan-resume mode, use the following
BUSY BUSY BUSY
41 RESUME." 41 RESUME 41 RESUME
41 RESUME
M
ANUAL
S
O
PTIONS
CANNING
45