Memory Operation; Memory Storage; Storing Independent Trasmit; Frequencies ("Odd Splits") - Yaesu FT-250R Operating Manual

Memory Operation

The FT-250R provides a wide variety of memory system resources. These include:
199 "Standard" memory channels, numbered "1 1 1 1 1 " through "199
A Home channel, allowing storage and quick recall of one prime frequency.
Five sets of band-edge memories also known as "Programming Memory Scan" chan-
nels, labeled "L1
L1 L1/U1 L1
L1
Select the desired frequency, while operating in the VFO mode. Be sure to set up any
desired CTCSS or DCS tones, as well as any desired repeater offset.
Press and hold in the [ MR/MW ( SKIP ) ] key for one second.
Within five seconds of releasing the [ MR/MW ( SKIP ) ] key, rotate the DIAL to select
the desired memory channel number.
Press the [ MR/MW ( SKIP ) ] key once more to store the frequency into memory.
You still will be operating in the "VFO" mode, so you may now enter other frequen-
cies, and store them into additional memory locations, by repeating the above process.
S I
TORING NDEPENDENT
All memories can store an independent transmit frequency, for operation on repeaters
with non-standard shift. To do this:
Store the receive frequency using the method already described under MEMORY STOR-
AGE (it doesn't matter if a repeater offset is active).
Turn to the desired transmit frequency, then press and hold the [ MR/MW ( SKIP ) ] key for
one second.
Within five seconds of releasing the [ MR/MW ( SKIP ) ] key, rotate the DIAL to select
the same memory channel number as used in step
Press and hold the PTT switch. Then while holding the PTT switch in, momentarily
press the [ MR/MW ( SKIP ) ] key once more (this does not key the transmitter).
Whenever you recall a memory which contains independently-stored transmit and re-
ceive frequencies, the "[–][ + ]" indication will appear in the display.
The "Odd Splits" feature permits setting TONE/DCS individually for transmit and re-
ceive. Briefly, press the [F/L] key, and then press the [2(CODE)] key. Rotate the DIAL
knob to select the TONE or DCS for receive. You can confirm the Transmit and receive
TONE/DCS by alternately pressing of the [REV(HOME)] key.
While operating in the VFO mode, press the [ MR/MW ( SKIP ) ] key. The "MR
tor will show that you are now in the Memory Recall mode.
Rotate the DIAL to select the desired channel.
To return to the VFO mode, press the [ VFO ( PRI ) ] key.
An easy way to recall memories is to key in the memory channel number, then press
[ MR/MW ( SKIP ) ] .
For example, to recall memory channel #16, press [ 1 ] - [ 6 ] - [ MR/MW ( SKIP ) ] .
18
U1" through "L5
U1 U1 L5 L5/U5 L5 U5 U5" U5
U1 L5 U5
M
EMORY
T
RANSMIT
M
EMORY
S
TORAGE
F
REQUENCIES
above.
R
ECALL
FT-250R O
199." 199 199 199
( "O
S
DD PLITS
MR" indica-
MR MR MR
M
PERATING ANUAL
" )