Table of Contents
Advertisement
mower with a tractor that does not meet the following requirements may cause tractor or mower damage and
be a potential danger to the operator and passersby.
Tractor Requirements and Capabilities
•
ASAE approved Roll-Over Protective Structure (ROPS) or ROPS cab and seat belt.
•
Tractor Safety Devices .................... Slow Moving Vehicle (SMV) emblem, lighting,
•
Tractor Horsepower -Minimum ........ Eagle 20 75HP; Eagle14 75HP
•
Drawbar............................................ 14" length for 540 RPM unit; 16" or 20" length for 1000 RPM unit, if
mower is equipped with Pintle Hook (Optional Equipment)drawbar length must be modified (see 3.4 Draw-
bar), rated to carry weight of mower, safety chain attachment point
•
Tongue Weight ................................. Eagle 20 - 2650lbs., Eagle 14 - 2600lbs.
•
Hydraulics ........................................ Minimum of 1 hydraulic port (extra 3-spool valve required). Minimum
2 ports, 3 ports recommended if additional,3-spool control valve is not used.
•
Front End Weights............................ As needed to maintain 20% weight on front axle
•
Power Take Off ................................ 540 RPM 6-spline or 1000 RPM 21-spline, 1-3/8" diameter output
shaft depending on mower operating speed.
For other PTO & Drawbar Category Combinations see your Tractor specifications.
2.1 ROPS and Seat Belt
The tractor must be equipped with a Roll-Over-Protective-Structure (ROPS) (tractor cab or roll-bar) and seat
belt to protect the operator from falling off the tractor, especially during a roll over where the driver could be
crushed and killed. Only operate the tractor with the ROPS in the raised position and seat belt fastened.
Tractor model not equipped with a ROPS and seat belt should have these life saving features installed by an
authorized dealer. OPS-U- 0003
Operate this Equipment only with a Tractor equipped with an approved roll-
over-protective system (ROPS). Always wear seat belts. Serious injury or
even death could result from falling off the tractor--particularly during a turnover
when the operator could be pinned under the ROPS.
Eagle 20 03/09
© 2009 Alamo Group Inc.
OPERATION
PTO master shield
Drawbar
Tractor
Category
Horsepower
I
75
II
75
III
75
Operation Section 4-5
PTO
Drawbar
TYPE
Length
1-3/8"-21
16"
1-3/4"-20
20"
1-3/8"-6
14"
(SG-7)
Advertisement
Table of Contents
