Table of Contents
Advertisement
Simrad ES333-7C
Cable gland for steel hulls
26
This cable gland kit is designed for steel vessels. It must be
welded to the hull plates.
Steel conduit
A
B
Stuffing tube, DNV approved carbon steel st52.3
C
Washers
D
Rubber gasket
E
Packing nipple. Make sure that you do not damage the
transducer cable by tightening the packing nipple too hard!
F
Cable to the echo sounder (or a junction box)
The cable gland kit includes all of the necessary parts needed to
install the unit except screws.
Simrad recommends that a one inch steel conduit (that the
transducer cable will be run through) with an inside threaded
diameter of three-quarter inches is welded to the gland's stuffing
tube. The conduit must extend to above the vessel's water line.
329786/A
Advertisement
Table of Contents
