Omix-Ada Rugged Ridge Alloy 11349.12 Manual

Side window air/rain deflectors

Download this manual

Note: Application and product my vary from illustrations. Caution: Before driving, ensure that all deflectors

are secured properly.

Please read all instructions before installation of Wind/Rain Deflectors

Preparations Before Installation

∙ Check and determine if Wind/Rain Deflectors are the correct fit for your vehicle.

∙ Wash and Clean all mounting surfaces of the vehicle using Isopropyl Alcohol (Rubbing Alcohol).

∙ To ensure proper bond apply only when temperatures of mounting surfaces is between 65-110°F.

∙ Be sure all mounting surfaces are dry before installation

1. Clean the painted surface where the deflector will be

attached using Isopropyl Alcohol (Rubbing Alcohol).

2. Hold and position deflector to determine mounting position.

3. Remove 2" of tape liner from each end of the deflector.

Side Window Air/Rain Deflectors

Page 1/2

, Inc.

Need help?

Do you have a question about the Rugged Ridge Alloy 11349.12 and is the answer not in the manual?

Page 1 2. Hold and position deflector to determine mounting position. 3. Remove 2” of tape liner from each end of the deflector. 460 Horizon Drive #400 | Suwanee, GA 30024 USA | www.omix-ada.com | Copyright © 2013 Omix-Ada ® , Inc.
Page 2 5. Once the deflector is positioned, carefully pull and remove the tape liner. Apply firm pressure along mounting surfaces to secure. 6. Apply same methods to the rear deflectors (if applicable). 460 Horizon Drive #400 | Suwanee, GA 30024 USA | www.omix-ada.com | Copyright © 2013 Omix-Ada ® , Inc.