LitterMaid P-70015 Manual

Step 1
Begin by preparing the waste receptacle. Place the receptacle underneath the compartment cover
in the space provided. Make sure that the front edge is under the 5 tabs on the front edge of the
litter tray.
Attach the waste receptacle lid by inserting the PUSH tabs into the round holes on the
compartment cover. Secure the lid by slipping the edges under the tabs on the waste receptacle
compartment cover.
Step 2
Next, finish preparing the waste receptacle by removing the carbon filter from the plastic sleeve
and peeling off the paper strip to expose the adhesive.
Place filter, adhesive side down, in diamond shaped insert in the center of the waste receptacle
lid.
Step 3
Attach the paw cleaning ramp by snapping the two notches into the attachment posts on the top
housing, directly in front of the waste receptacle compartment cover.
Tug slightly on the ramp to ensure that it is firmly in place.
Step 4
Finally, fill the litter tray so that the litter level is between the min and max fill lines on either
side of the box. All clumping litters are safe to use with this box!
Use the scoop to evenly distribute litter in the litter tray.