Advertisement

Kitty Kabana
LITTER BOX COVER

Getting Started

Make sure you have all of the parts listed below
1.
Transparent tubes (2)
2.
Metallic rod
3.
Curved tubes (already preassembled in kabana)
4.
Preassembled Kabana
To ssemble
1. Insert the metallic rod through the
looped fabric located on top of the
preassembled kabana ( ).
D
B
2. Position the ends of the metallic rod over the curved tubes that are already
preassembled inside the kabana (B).
3. Press the ends of the metallic rod into the curved tubes, (where the kabana's fabric
has an opening), until it snaps into place (C).
Note: The two remaining transparent tubes are installed at the end.
How to install the LitterMaid Kitty Kabana™ onto
your LitterMaid® Litter Box
1. Remove the 4 plugs located on the corners of the litter box's top housing (D).
Models
LMT250
LME9000MW
LME9250
3
2
C
4
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LitterMaid Elite LME9250 and is the answer not in the manual?

Questions and answers

Summary of Contents for LitterMaid LitterMaid Elite LME9250

  • Page 1: Getting Started

    Kitty Kabana LITTER BOX COVER Getting Started Make sure you have all of the parts listed below Transparent tubes (2) Metallic rod Curved tubes (already preassembled in kabana) Preassembled Kabana To ssemble 1. Insert the metallic rod through the looped fabric located on top of the preassembled kabana ( ).
  • Page 2: Care And Cleaning

    Care and Cleaning 1. From time to time, wipe the outer surface of the kabana with a damp soft cloth. 2. For a thorough cleaning, remove the kabana from the litter box. 3. Disassemble the kabana for cleaning the same way it was assembled. 4.

This manual is also suitable for:

Kitty kabana lmt250Kitty kabana lme9000mwKitty kabana lme9250

Table of Contents