Page 1
FOR EXTRA-LARGE CATS OR MULTIPLE CAT HOUSEHOLDS Register your product online at www.prodprotect.com/applica, for a chance to WIN $100,000! For US residents only US /Canada 1-800-LITM ID (548-6243) www.littermaid.com Model ccessories/Parts (US /Canada) 1-800-738-0245 ❑ LME9000MW Please Read and Save this Use and Care Book...
IMPORT NT S FEGU RDS WELCOME TO THE F MILY! Instructions pertaining to a risk of fire, electric shock or injury to persons. Congratulations on your purchase of the LitterMaid ® dvanced utomatic W RNING: When using electric appliances, basic precautions should always be followed including the following: Self-Cleaning Litter Box. This product is designed to make caring for your cat a simpler, less time-consuming process. 1. Read all the instructions before using the appliance. OPER TING INSTRUCTIONS FOR THE LITTERM ID ® SELF-CLE NING 2. To reduce the risk of injury, close supervision is necessary when LITTER BOX an appliance is used near children. • Cat enters the unit; once he/she leaves, the sensors are triggered, setting 3. Do not contact moving parts. the timer for the cleaning cycle (sensors need to be blocked for at least 4. Only use attachments recommended or sold by the manufacturer. 5 seconds). 5. Do not use outdoors. Important: Unit will not start a cleaning cycle while cat is in the box. ® 6. To reduce the risk of electric shock, do not put LitterMaid • s soon as the cat leaves the litter box, the sensors activate the dvanced utomatic Self-Cleaning Litter Box in water or other 10-minute countdown and the ionic air cleaner.
Page 3
† 4. LitterMaid scoop and rake cleaner (Part# LME9000MW-10) † 4. Battery compartment cover (Part# LME9000MW-01) (batteries not included) † 5. Paw cleaning ramp (Part# LME9000MW-11) 5. Blue LED ionizer light † 6. Carbon Filters (8 included) (Part# LMF200) (12 pk.) 6. Ionic air cleaner † 7. Disposable waste receptacle (8 included) 7. Motor housing (12 pk.) (Part# LMR200) † 8. Removable rake (Part# LME9000MW-02) (18 pk.) (Part# LMR300) † 9. Litter tray (Part# LME9000MW-03) † Consumer replaceable/removable parts 10. Sensors (both sides) † 11. Waste receptacle compartment cover with flaps (Part# LME9000MW-04) 12. Receptacle supports Right (Part# LME9000MW-05) and Left (Part# LME9000W-06) 13. Top housing 14. Plug holes for Plug 2 (1 each side) 15. Cutout handle (1 each side) 16. Plug holes for Plug 1 (1 each side) † Consumer replaceable/removable parts...
Page 4
• Cut or remove the tie restraints on the underside of unit. 1. Press down. 2. Slide through. Before getting started be sure you have all of the following contents. Litter tray Top housing 1. Green LED POWER indicator light Waste receptacle compartment supports 2. Red LED SLEEP indicator light Waste receptacle compartment cover 3. Digital clock Rake 4. Time/Programming buttons C adapter (packed in styrofoam) Disposable waste receptacles Carbon filters ® Other LitterMaid ccessories LitterMaid™ scoop and rake cleaner Check our online service for parts and accessories at www.littermaid.com or call 1-800-548-6243 Use and care manual Model # Tent type 1 and 2 Plugs LitterMaid Kitty Kabana™ litter box cover (white) LMT200 Cleaning brush (packed with disposable waste receptacles) 1 LitterMaid Elite™ litter box cover (white) LMT250 Quick Start Sheet for litter box ® LitterMaid litter box carpet...
Page 5
(H). grooves on the bottom tray until they lock into place ( ). Make sure lid edges are under the cover tabs (J). 2. Place both left and right flaps flat on top of the waste receptacle compartment panel. 3. Push the flaps in and up until they click into place (B). 4. Lift the flaps until they lock into place (C). 9. Install carbon filter. • Peel off the paper strip on the carbon filter to expose the adhesive. • Place filter adhesive-side down in the diamond-shaped insert in the center of the waste receptacle lid (K). Close the waste receptacle compartment cover. 5. Snap each pivot of the waste receptacle compartment cover, 10. Fill the LitterMaid ® litter box with litter to just below the one at a time, into notches in the receptacle supports (D). Full Line marked inside of litter tray 6. Open waste receptacle compartment cover. Important: Use only hard clumping litter. Do not use non-clumping litter, crystal Important: Waste receptacle compartment cover must be or pearl-like litters. opened to remove and install top housing. Recommended Hard Clumping Litters • LitterMaid™ Hard Clumping Cat Litter 7. Lift top housing. ngle into position bracket end of top • World's Best Cat Litter™ housing under tray ledge. Important: 5 black tabs of the tray should be on top of the grey bar in front of the top housing • RM & H MMER ® Super Scoop ® The Baking Soda Clumping Litter (E). Bring the other end of top housing down so that it...
Page 6
• Plug the cord into a standard electrical wall outlet. 2. Steady red light comes on to indicate that the sleep mode is activated. • Press the ON/OFF button to turn unit ON. The rake will To Deactivate Sleep Mode automatically run through its first cleaning cycle and smooth out the litter. 1. Sleep mode must be activated (red LED lit) to be deactivated. 2. Press the SET button, steady red LED is no longer lit. Important: When the On/Off button is in the Off position it only disables the rake function. Ionic ir Cleaner • s soon as the cat leaves the litter box, the sensor activates the 10-minute 14. Place the 4 tent plugs into the 4 holes on top housing. countdown and the ionic air cleaner. Note: lways use both hands to move LitterMaid ® litter box by holding handle • The ionic air cleaner stays on during the countdown and the cleaning cycle. cutouts located on each side of the tray. OPTION L PROGR MM BLE TIME FUNCTION: The timer function allows you • If the sleep timer is activated the rake will not cycle for 9 hours from the set sleep mode time but the ionic air cleaner will automatically turn on every hour to deactivate the unit for up to 9 hours at your convenience. Once the time is up, it will restart again and run one cycle. To program the timer, you must first set the for 10 minutes. clock. Optional Items: Setting the clock For more information, call 1-800-738-0245 or visit our website: www.littermaid.com...
Helpful Information • If your cat is shy, do not operate the LitterMaid ® litter box automatically for 2 to 3 days. Do it manually by pressing the ON/OFF button once and then If you need to acclimate your cat to the LitterMaid ® dvanced utomatic turning it off. Self-Cleaning litter box, refer to " cclimating Your Cat" in this use and care book. • Manually activate the LitterMaid ® litter box 2 to 3 times a day for the first Unit will work without setting the clock when unit is turned on. ® 2 to 3 days, to let your cat get used to going into the LitterMaid litter box, and If your unit is not working properly, refer to "Troubleshooting" in this use and care how it sounds and works; you can then set it to clean automatically. book. ™ • s soon as your cat is acclimated to the LitterMaid litter box, set it to clean Batteries (We recommend using batteries only as a back-up): automatically. Press the ON/OFF button to ON and remove the old litter box. • Push up on center ridges to open battery compartment door. Note: Do not place your LitterMaid ® litter box in a wet environment or in direct • Remove the battery door. sunlight. Do not use outdoors or on patios. • Follow the diagram in the compartment to install 8...
Rake Removal & Cleaning Solution: Removing the rake: 1. Press the ON/OFF button to turn unit OFF. The rake can be removed for easy cleaning. Important: When the On/Off button is in the Off position it only disables We recommend wearing rubber or latex gloves when handling the soiled rake. the rake function. • Be sure rake is in the home position and unit is turned off. 2. Clear the obstacle. Be sure litter in tray is just below the "Full Line". Level litter on litter tray • Grasp rake ledge underneath logo and slide up and off of unit. evenly and use the LitterMaid ® scoop and rake cleaner to measure the • Clean rake with a soft cloth using warm water and mild detergent. Do not use level of the litter in the center of the unit. Full Line will not be visible if scouring pads or harsh or abrasive chemicals. Spray rake lightly with nonstick tray is overfilled. cooking spray or a silicone spray before reinstalling. 3. Press the ON/OFF button ON. Note: Rake may be cleaned while installed by using the LitterMaid ® scoop and rake cleaner. 4. The rake will run through a complete cleaning cycle. When cycle is finished, the unit is ready for use. Paw-Cleaning Ramp: The carpet is made of 100% polypropylene and latex foam. Unit does not operate 10 minutes after cat leaves. To Clean: Probable Cause: • Remove mat by gently pulling on the fabric strip provided...
Page 9
Unit does not completely clean litter box. Solution: Probable Cause: Press ON/OFF button OFF and check the following: Important: When the On/Off button is in the Off position it only disables the • Low-quality litter. rake function. Solution: 1. The C adapter plug is inserted fully into the input jack. 1. Do not use non-clumping, crystal or pearl-like litter. 2. The power outlet is operating. (you may wish to double-check by plugging 2. Use only hard clumping litter. unit into another outlet). Unit does not operate when you press ON/OFF button to turn unit ON. 3. Wait a few seconds and turn unit on again. Green light should come on Important: When the On/Off button is in the Off position it only disables the and the unit should perform a complete cleaning cycle. rake function. 4. If unit still does not operate, press ON/OFF button OFF and unplug the C Probable Cause: adapter. • Power outage • Faulty or non-activated outlet 5. Operate the unit on battery power only. • Old batteries Waste clumps adhere to the surface of the litter tray. Solution: Probable Cause: • Check batteries and outlet • Soiled litter tray surface • Use batteries in case of power outage Solution: • Switch to battery power...
Page 10
3. Remove batteries. rake will return to its home position, and the green light will blink slowly 4. Clean unit (check track for litter). (approximately every second), indicating that the rake has encountered an obstacle it cannot move. 5. Wipe sensors. Solution: 6. Put unit together and plug into C power only and press ON/OFF button to turn unit ON for the automatic cycle. 1. Press ON/OFF button OFF. Important: When the On/Off button is in the Off position it only disables the If the Rake stops in the dump position rake function. 2. Use the LitterMaid™ scoop and rake cleaner to remove the obstacle. Press ON/OFF button OFF 3. Make sure that the rake teeth are clean and free of litter. Use the LitterMaid ® Examine the Home position switch for obstruction (litter) preventing the switch scoop and rake cleaner to clean rake teeth. lever arm from releasing 4. Press ON/OFF button ON. Carefully remove the obstruction using tooth pick or dental instrument Press ON/OFF button turn unit ON Power light blinks quickly. The rake should automatically return to the Home position. Probable Cause: If not, contact the Consumer ssistance Number for direction • Batteries need replacing. Solution: If blue LED ionizer light is off. Solution: Light will continue to blink until batteries are removed or until they are completely dead.
NEED HELP? For service, repair or any questions regarding your appliance, call the appropriate "800" number on the cover of this book. Do not return the product to the place of purchase. Do not mail the product back to the manufacturer nor bring it to a service center. You may also want to consult the website listed on the cover of this manual. Two-Year Limited Warranty ( pplies only in the United States and Canada) What does it cover? • ny defect in material or workmanship; provided; however, pplica’s liability will not exceed the purchase price of the product For how long? • Two years after the date of original purchase What will we do to help you? • Provide you with a reasonably similar replacement product that is either new or factory refurbished How do you get service? • Save your receipt as proof of the date of sale. • Check our on-line service site at www.prodprotect.com/applica, or call our toll-free number, 1-800-548-6243, for general warranty service or If you need parts or accessories, please call 1-800-738-0245. What does your warranty not cover? • Damage from commercial use • Damage from misuse, abuse or neglect • Products that have been modified in any way • Products used or serviced outside the country of purchase • Glass parts and other accessory items that are packed with the unit • Shipping and handling costs associated with the replacement of the unit • Consequential or incidental damages (Please note, however, that some states do not allow the exclusion or limitation of consequential or incidental damages, so this limitation may not apply to you.) How does state law relate to this warranty? • This warranty gives you specific legal rights, and you may also have other rights that vary from state to state or province to province. ® ® RM & H MMER and Super Scoop are registered trademarks of Church & Dwight Co., Inc.
Need help?
Do you have a question about the LME9000MW and is the answer not in the manual?
Questions and answers