American Standard STUDIO S 7105857 Installation Instructions

STUDIO S
®
DUAL CONTROL WIDESPREAD
LAVATORY FAUCET
Thank you for selecting American Standard...
the benchmark of fine quality for over 140 years.
To ensure that your installation proceeds smoothly-please read
these instructions carefully before you begin.
RECOMMENDED TOOLS
Flat Head Screwdriver
1
INSTALL SPOUT
Fig. A.
• Insert SHANK (1) and HOSE (2) through center hole, making sure
SEAL WASHER (3) is properly seated in spout base.
• From below, push GASKET (5) with RETAINING WASHER (6) onto MOUNTING
STUD (4). Secure faucet with MOUNTING NUT (14), pushing faucet to back of
sink, so SUPPLIES (3) rests against mounting hole.
• Align and center SPOUT. Tighten LOCKNUT (5).
1A
INSTALL VALVE BODIES
Fig. B.
• Place SEAL WASHER (7) under HANDLE BASE (8)
and make sure it sits properly inside the groove of
the deck adapter.
• Remove LOCKNUT (9) and RUBBER WASHER
(10), FRICTION WASHER (10a) from SIDE VALVE
SHANKS (11).
• Insert Hot and Cold SIDE VALVE HOSES (12),
FLEXIBLE SUPPLIES (13a) into mounting holes
making sure the SEAL WASHERS (7) are
properly seated in each HANDLE BASE (8).
• Assemble SPACER (13) RUBBER WASHER (10),
FRICTION WASHER (11a) and thread LOCKNUT
(10a) onto each SIDE VALVE SHANK (11) from
underside of sink or mounting surface.
NOTE: SPACER (13) not needed for deck
thickness larger then 3-1/4".
• Align and center SIDE VALVES. Tighten
LOCKNUTS (9).
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2018
INSTALLATION
INSTRUCTIONS
Slip Jaw Pliers
Turn off hot and cold water
CAUTION
supplies before begining.
10a
12 Red Stripe
7105857
7105877
Adjustable Wrench Tubing Cutter
Fig. B.
8
7
11
13
10
10
13a
(HOT)
- 1 -
Certified to comply with ANSI A112.18.1M
Hex Wrench
Fig. A.
SPOUT BASE
4
1
13a
12 Blue Stripe (COLD)
3
2
5
6
14
M965956 (6/18)