About The Rp100; Performance Mode; Bypass Mode - DigiTech RP100 User Manual

About the RP100

The Presets
Presets are numbered locations of programmed sounds which reside in the RP100. Presets are
recalled with the Footswitches.The active effects in each Preset will be indicated by the lighted
LEDs in the Effect Matrix.The RP100 comes with 40 User Presets (Presets 1-40) and 40 Factory
Presets (Presets 41-80).The User Presets are locations where your creations may be stored.The
Factory Presets will not allow you to store any changes to them. From the factory, the 40 User
Presets are exact duplicates of the 40 Factory Presets.This allows you to make your own Presets
without the worry of losing any of the sounds that the RP100 came with.

Performance Mode

When you first apply power to the RP100, it will power up in Performance mode. Performance
mode provides access to all of the Presets within the RP100 via the Right and Left
Footswitches.The Parameter 1 (left) knob will adjust the Amp Gain (distortion), the
Parameter 2 (middle) knob will select the Amp Type, and the Parameter 3 (right) knob will
adjust the Master Level (volume).

Bypass Mode

The RP100 Presets can be bypassed for a clean, unprocessed guitar tone.To bypass the RP100,
press both Footswitches simultaneously.The Display will read By indicating the Preset is
bypassed. Pressing both Footswitches simultaneously again will exit Bypass and return the
RP100 to the last Preset used.
10