Section 2 - Basic Operations; About Rp-6'S Modes; Program Mode; Bank Mode - DigiTech RP6 Owner's Manual

10

SECTION 2 - BASIC OPERATIONS

ABOUT THE RP-6 MODES

PROGRAM MODE

BANK MODE

EDIT MODE

Section 2 - Basic Operations
The RP-6 offers five modes, allowing easy operation of the Effects and
Parameters. The modes are as follows:
Allows you to scroll through the 40 Programs by using the <UP> and
<DOWN> Value keys as well as the <UP> and <DOWN> footswitch-
es. Enter Program mode by pressing the <UP> and <DOWN>
footswitches simultaneously until the Program LED lights and a P
appears briefly in the display window. Footswitches 1-4 act as on/off
toggle switches for the specified effects. Exit Program mode by
changing to another mode.
Allows you to scroll quickly through Banks without going through
every Program to get to the next Bank. Enter Bank mode by pressing
the <UP> and <DOWN> footswitches simultaneously until the Bank
LED lights and a B appears briefly in the display window. When you
enter Bank mode, the Bank and Program numbers from the previous
mode will be retained. When a Program number is displayed in the
third LED of the display window, you can use the Value <UP> and
<DOWN> keys to scroll through Programs and Banks. This works
exactly like Program mode.
When the <UP> and <DOWN> footswitches are used in Bank mode,
you will scroll through Banks only. When you change a Bank using
this method, the previous Program number is not displayed with the
new Bank. The LEDs above footswitches 1-4 will begin flashing, indi-
cating that you can choose a Program in the selected Bank by press-
ing one of the four footswitches. Once a Program number has been
selected, both the Bank and Program numbers will be displayed. Exit
Bank mode by changing to another mode.
Allows you to change Effects and Parameters in a Program. Enter Edit
mode by pressing the <EDIT> key. The Display window now shows
the value of the Parameter indicated by the LEDs in the Matrix. You
can scroll through the Parameter matrix using the Parameter Select
keys. The <UP> and <DOWN> keys allow you to scroll through the
vertical Parameter LEDs, while the <LEFT> and <RIGHT> keys allow
you to scroll through the horizontal Effect LEDs.
After selecting a Parameter, you can scroll through its values with the
<UP> and <DOWN> Data keys. When moving through Parameter val-
ues, the decimal point next to the Parameter value will flash when a
stored value has been changed. If you return to the original value, the
decimal point will stop flashing. If you exit Edit mode after changing
the Parameters and then return to Edit mode, the last viewed
Parameter will be displayed.
RP-6 Owner's Manual