Setting A Loop Tempo For Recording - DigiTech JAMMAN SOLO Owner's Manual

Setting a Loop Tempo for Recording

Before you begin recording a phrase, you may want to set a tempo at which you want to
record the loop at. Setting the tempo in an empty loop memory location automatically
starts playing the rhythm guide track (Rhythm Level must be turned up to hear it). You can
use the rhythm guide track as a metronome for recording against to help keep a consistent
tempo of your performance. To set the tempo for recording, follow these steps:
Select an empty loop memory location
1
using the LOOP SELECT buttons
(LOOP and SINGLE LEDs are off).
Tap the TEMPO button at least two times, or if
Pedal Tempo is enabled, press the PEDAL
2
SWITCH at least two times. The TEMPO button
will begin flashing at the tempo that has been
tapped in. The first downbeat of the measure
flashes red and the other beats flash green. If
Pedal Tempo is enabled, you must press and hold
the PEDAL SWITCH for two seconds to fix the
tempo before you can record.
To set up a memory location with a tempo but not record to it, follow steps 1 and 2 and
then store the new tempo using the Store procedure. When you return to the empty loop
location, the tempo will already be set as indicated by the Tempo button flashing.
24
Turn up the RHYTHM LEVEL
3
knob (if it hasn't been already)
to hear the rhythm guide track.
To begin recording, press the
4
PEDAL SWITCH, wait for the
one-measure count-in, and
begin playing.