Arkon Slim-Grip Ultra SM679 Manual

SM679 | Slim-Grip® Ultra™ Multi-Surface Sticky Suction Mount
AP013 GN079-SBH
*If the sticky suction base becomes dirty or loses stickiness, rinse under warm water with mild liquid soap and let air dry.
1
Attach mount to dash or windshield, engage suction lock. Connect
holder to the mount.
Push down on P
Suction Lock
suction base
Lever Lever
IMPORTANT: With certain dashboard surfaces you may IMPORTANT:
With certain dashboard surfaces you may
need to push down fi rmly on the suction base while need to push down fi rmly on the suction base while
engaging the suction lock lever to create enough suction engaging the suction lock lever to create enough suction
to hold the mount. to hold the mount.
3
Adjust support legs if necessary.
Select the appropriate size support legs and install
to holder. For large smartphones, midsize tablets,
and large cases, use included long support legs.
Safety Precautions
!
Do not install Arkon products over an air bag cover or within the air bag deployment
zone. Arkon Resources, Inc. assumes no responsibility of liability for injury or death as a
result of car crashes and / or air bag deployment.
Arkon is not responsible for any damages caused to your vehicle, your device, or yourself due
to the installation or use of this pedestal mount.
SM060-2
Attach holder to
mount
Slide Legs to adjust Slide Legs to adjust
Package Contents:
GN079-SBH – Multi-Surface Sticky Suction Mount
SM060-2 – Slim-Grip® Ultra™ Holder
AP013 – 80mm Adhesive Mounting Disk
DASHBOARD MOUNTING WARNING: THE STICKY SUCTION PEDESTAL SHOULD NOT BE USED
ON SOME TYPES OF DASHBOARDS. IT MAY LEAVE A PERMANENT INDENTATION ON DASHBOARD
SURFACES MADE OF SOFT VINYL, LEATHER, OR SIMILAR MATERIALS. TO PREVENT PERMANENT
INDENTATION MARKS, USE THE INCLUDED ADHESIVE MOUNTING DISK WHEN MOUNTING ON SOFT
DASHBOARD SURFACES.
2
Insert device, adjust mount as needed.
*If necessary, use included long legs for large devices or cases. *If necessary, use included long legs for large devices or cases.
OPTIONAL: For use on soft vinyl or leather dashboards, use included
adhesive mounting disk*.
*Let mounting disk adhesive cure for 24 hours before use. *Let mounting disk adhesive cure for 24 hours before use.
Consumer Hotline:
USA
(800) 841-0884
INT'L (626) 254-9005
Monday - Friday 9am - 5pm, PST
rev.091119
Adjustment Adjustment
Knob Knob
Adjustment Adjustment
Ring Ring
Push down on lower legs Push down on lower legs
to mount device to mount device
Adhesive Mounting
Disk* Disk*
www.arkon.com
Arcadia, CA 91006 USA
Designed in USA | Made in China
© Copyright 2019 Arkon Resources, Inc.