Voice Communication; Audio Modes; Volume Control; Accessing The Dialer Window - Honeywell 9900LUP-6211G0 - Hand Held Products Dolphin 9900 User Manual

Voice Communication

You can use the Dolphin terminal as a phone over the GSM radio.

Audio Modes

The back panel of the 9900, 9950, and 9951 contains both a speaker and a microphone that you can use
to send and receive audio signals over the GSM network; see
There are two audio modes:
Headset Headset mode is when you plug a headset into the audio jack and speak into the microphone. You
must use a 2.5mm plug; no other audio plug will fit.
Hands-Free Hands-free mode is when you use the back panel as a speakerphone. To switch the back panel to
speakerphone, in the Dialler, tap Settings > Speakerphone . The audio levels adjust appropriately
for speakerphone use.

Volume Control

Use the Dolphin keyboard to manually adjust the volume.
VOL
To raise the volume, press the Blue modifier key + up arrow.
PG
To lower the volume, press the Blue modifier key + down arrow.

Accessing the Dialer Window

When the GSM radio is active, tap Start > Settings > Connections tab > Dolphin Wireless Manager,
then tap Menu > Phone Settings. The Phone dialer opens.
Displays the network
carrier from the SIM card.
Displays the most
recent calls.

Dialing

Once the dialer window is open you can dial out two ways:
• Tap the buttons on the dialer window.
• Use the physical keyboard (when it's in numeric mode).
Back Panel: 9900 on page 3-6.
8 - 5