curt 13270 Manual

13270
9/20/2007
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH:
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH:
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
Parts List
ITEM QTY PART NUMBER
1 4 M14-2 x 40mm LG.
2 4 9/16
3 4 9_16 WASHER
3
1 2
37
HITCH WEIGHT: LBS.
INSTALL TIME: 30 MINUTES
INSTALL NOTES:
- NO DRILLING REQUIRED
- LOWER EXHAUST
INSTALLATION STEPS
1) Remove 2 existing bolts from each frame rail as shown.
(NOTE: Lower exhaust for ease of installation)
2) Raise hitch into position, in front of the spring shackle brackets.
3) Install supplied 14mm bolts lock washers and flat washers as shown.
4) Torque all 14mm fasteners to 94 lb-ft.
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
HUMMER H3
DESCRIPTION
HEX TAP BOLT
LOCK WASHER
FLAT WASHER
PASSENGER SIDE FRAME RAIL
DRIVER SIDE FRAME RAIL
EXISTING WELDNUTS
REAR SPRING
SPRING SHACKLE BRACKET
SPRING SHACKLE BRACKET
5,000 LBS. TRAILER WEIGHT &
5,500
LBS. TRAILER WEIGHT &
500 LBS. TONGUE WEIGHT.
550 LBS. TONGUE WEIGHT
INSTALLED HITCH POSITION
2/6/07 10/28/2006