Table of Contents
Advertisement
Driveline Attachment
Before starting assembly, make certain that all paint, dirt, and grease are removed from gearbox shaft (1). To
ease assembly apply a light coat of grease to splines and assemble. Do not assemble a driveline without a
shield. Entanglement in rotating shafts can kill.
.
1. Attach the slip clutch end of the driveline to the
gearbox input shaft securely. (Figure Asm-
0090) Make certain that the slip clutch is fully
onto the input shaft splines.
locknuts (2) alternately until they have reached
the proper torque. Refer to Torque Chart in the
Maintenance Section.
SLIP CLUTCH SHIELD ASSEMBLY
To attach the Slip Clutch Shield, follow the
procedures listed below (Figure Asm-R-0091).
1. Guide shield bracket (2) through weldment
shield (1) so that bracket stud screw potrudes
through weldment hole and retain in place with
wingnut (3).
2. Align holes of shield bracket with gearbox holes
positioned around input shaft. Retain bracket to
gearbox with three 3/8" x 3/4" bolts (6), 3/8"
washers
(4),
and
Position hardware as follows:
bracket, flatwasher, lockwasher, bolt. Tighten
bolts to recommended torque.
A60B/A72B
02/07
©2007 Alamo Group Inc.
ASSEMBLY
Tighten the
3/8"
lockwashers
(5).
gearbox,
Assembly Section 3-6
Advertisement
Table of Contents
