STREET WISE SWLG165 Series Manual

Stun Warning Light
Test Probes
LED Flashlight
Contact Probes
CHARGING THE BATTERIES
1. The rechargeable batteries are already installed. The unit cannot be opened, as this will void the warranty.
2. Before use, the stun gun will need to be charged for 8 hours. Insert the slide-out plug on the bottom of the
unit into a standard outlet. The Charging Indicator Light will come on while charging.
IMPORTANT: Do not charge for more than 8 hours at a time. Overcharging can damage the unit and
void the warranty. Under normal use the unit will need to be recharged for 8 hours every 60 days. If the
LED Flashlight is used frequently or if the electrical charge produced by the stun gun becomes noticeably
weaker, the unit will need to be recharged.
USING THE FLASHLIGHT
1. Slide the Safety Switch located on the side of the unit up to the middle position to turn on the LED
Flashlight.
2. Slide the Safety Switch down to turn off the light.
TESTING THE STUN GUN
WARNING: Do not test fire the stun gun for more than 1 second as this will damage the unit and void the
warranty.
1. Slide the Safety Switch located on the side of the unit up to the top position to turn off the safety. The Stun
Warning Light above the Stun Activation Button will illuminate. Note: The Safety Pin (attached to the wrist
strap) must be inserted into the bottom of the unit in order for the stun to operate.
2. Press the Stun Activation Button on the side of the unit (just above the Safety Switch) to test the stun
gun. You will both see and hear an electrical charge fire across the top of the unit between the Contact
Probes.
3. When test firing the unit, do not hold the button down for more than 1 second. Slide the Safety Switch
down to the bottom position to turn the safety back on. The Stun Warning Light will turn off.
SWLG165 Series
Instructions
Stun Activation Button
Safety Switch
Wrist Lanyard
w/Disable Pin
Built-In Charger
Safety Pin Port
Rev 8/22/2019