STREET WISE SWS24 Series Instructions

CHARGING THE BATTERIES
1. The rechargeable batteries are already installed. The unit cannot be opened, as this could damage
the unit and will void the warranty.
2. Before use, the stun gun will need to be charged for 3-4 hours.
3. Using the included USB charging cord, plug the mini USB end into the charging port on the stun gun (2) and the other
end into your USB charging device (computer, wall or block charger, or car plug). The Battery Indicator Lights (3) will
flash while charging. Four solid lights indicate a full charge.
IMPORTANT: Do not charge for more than 4 hours at a time.
USING THE LED FLASHLIGHT
1. Place your finger on the Touch Sensor (6) to activate the LED Light (5). The Battery Indicator Lights (3) will show how
much power is remaining.
2. Remove your finger to turn off the light.
3. To prevent draining the battery the flashlight will turn off after 20 seconds of constant use. Simply touch again to turn it
back on.
TESTING THE STUN GUN
WARNING: Do not test fire the stun gun for more than one second as this will damage the unit and void the warranty.
1. Turn off the safety by placing your finger on the Touch Sensor (6). Note: the LED Light (5) and Battery Indicator
Lights (3) will turn on.
2. With your thumb, press the Stun Activation Button (1). You will see an electrical charge fire across the top of the unit
between the Stun Contact Probes (4).
3. When test firing the unit, do not hold for more than 1 second.
SMART KEYCHAIN STUN GUN 24,000,000
SWS24 Series
Instructions
Rev 6/21/2019