Table of Contents
Advertisement
Connecting the Power Cord
Connecting the Power Cord
Plug the power cord into a 230 V, 50 Hz, earthed (3-prong) AC outlet.
Caution!
♦
Make sure you have removed all of the packing tape before plugging
in the power cord (see page 9). Plugging in the power cord without doing
so may damage the machine.
♦
The power outlet should be installed near the equipment and be easily
accessible.
The machine does not have
a power on/off switch, so
the power is turned on and
off by simply plugging in or
unplugging the power cord.
Note: If your area experiences a high incidence of lightning or power surges,
we recommend that you install surge protectors for the power and telephone
lines. Surge protectors can be purchased at most telephone specialty stores.
14
"CHECK CARTRIDGE" normally
appears in the display the first
time you plug in the machine.
This message appears until you
install the print cartridge.
Advertisement
Table of Contents
