Subscribe to Our Youtube Channel
Related Manuals for Siemens SSA911.02TH
Summary of Contents for Siemens SSA911.02TH
- Page 1 SSA911.02TH Wireless radiator valve actuator - Thread Operation Manual A6V16313372_en--_a Smart Infrastructure 2025-03-06...
- Page 2 Notes Safety 1 Notes 1.1 Safety Batteries Observe the following: ● Correct polarity. ● Use new batteries and check for damage ● Do not mix old and new batteries Store, transport and dispose of the batteries in compliance with local requirements, regulations, and laws.
-
Page 3: Cyber Security Disclaimer
Siemens’ portfolio undergoes continuous development to make it more secure. Siemens strongly recommends that updates are applied as soon as they are avail- able and that the latest versions are used. Use of versions that are no longer sup- ported, and failure to apply the latest updates may increase your exposure to cyber threats. - Page 4 A communications network is set up and a Thread Border Router is within range. The actuator stem on the wireless radiator valve actuator SSA911.02TH is fully retracted (delivery state). The valve stem is not jammed and can freely move.
- Page 5 Commissioning Off-site commissioning (uninstalled) 2.2 Off-site commissioning (uninstalled) We do not recommend commissioning devices uninstalled since unique identifica- tion in the control system cannot be guaranteed if multiple radiator valve actuators of the same type are installed (they are merely identified in the system by type designation).
-
Page 6: Operation
Operation Set temperature 3 Operation 3.1 Set temperature The setpoint temperature can only be set within the limits from the data point list. 1. Press one of the touch elements [1]. The display turns on. The present setpoint temperature is displayed. 2. - Page 7 Operation Key lock 3.3 Key lock The actuator displays the setpoint temperature if the key lock is enabled and the user presses a touch element. The key lock must be disabled to change the tem- perature. Enable key lock ◈ Simultaneously press both touch elements and hold for 6...8 seconds [A].
-
Page 8: Rotate Display
The wink function identifies radiator valve actuators. This is especially useful in parallel mode. Wink availability depends on the network where the SSA911.02TH is integrated. 1. Simultaneously press both touch elements and hold for 2...4 seconds [1]. The display switches on and displays W (= "Wink"). -
Page 9: Error Messages
Operation Error messages The SSA911.02TH sends a signal to the paired edge device. The radiator valve actuator is highlighted on the dashboard. The wireless radiator valve actuator display switches off after 10 seconds and the actuator goes into sleep mode. -
Page 10: Change Batteries
Operation Change batteries 1. In the event of an error, press one of the touch elements to switch on the dis- play. E4, E5: The setpoint temperature is displayed for 1...2 seconds; you can change the setpoint during this time. ... -
Page 11: Reset To Factory Settings
◈ Press the reset button in the battery compartment for approx. 10 seconds. A counter is displayed after 5 second to count from 5 to 10. The SSA911.02TH is reset to the factory settings. A6V16313372_en--_a 11 | 12... - Page 12 Issued by Siemens Switzerland Ltd Smart Infrastructure Global Headquarters Theilerstrasse 1a CH-6300 Zug +41 58 724 2424 www.siemens.com/buildingtechnologies © Siemens 2025 Technical specifications and availability subject to change without notice. A6V16313372_en--_a...
Need help?
Do you have a question about the SSA911.02TH and is the answer not in the manual?
Questions and answers