LuxenHome WHF2308 Instruction Manual

Product Name:
SKU #:
Thank you for purchasing this LuxenHöme product. This product has been manufactured with the highest
standards of safety and quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from the packaging inside the carton to ensure there are no missing or damaged parts. Do not
attempt to assemble or use the product if any parts are missing or damaged. Please save the carton for return
and/or storage.
Note: the pump is packaged separately inside the fountain shipping carton. Please check packaging thoroughly.
CARTON CONTENTS:
Description
Fountain
Pump
Compatible Pumps for this fountain:
Pump Model No.
JR450/LED
WP450/LED
YH707/LED
Tools required for assembly: No tools required for assembly.
Assembly Instructions:
1. Select a flat, level surface for your fountain's assembly and final location.
2. Insert the water supply tube into the pump outlet from the opening at the back of the fountain. Insert the LED
connector into the pump connector and twist it to tighten. Place the pump inside the back of the fountain and
draw the pump power cord out of the fountain back. Connect the power cord to the adapter plug.
3. Add clean water into the fountain. The water level should be approximately 30mm lower than the edge of the
reservoir. Ensure the pump in your fountain is completely submerged in the water.
4. Connect the pump power cord to a ground fault circuit interrupter (GFCI) outlet, and the product will begin to
function as intended.
5. Adjust the flow rate (if applicable) to the maximum (+) position. If necessary, readjust the flow rate to the
desired level (remember to always disconnect from the power source before handling the pump).
6. Please do not use the electrical plug during wet weather conditions. Please note: On first use, there may be air
in the pump. It may take several minutes until all the air escapes.
7. To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing
after the initial setup of your fountain. It is highly recommended that this fountain be placed where it cannot
be damaged. Check the area around your fountain regularly to ensure no leakage.
8. Do not leave your fountain running for extended periods when no one is present to observe the performance.
Cascading Gray with Speckled Black Rectangle Resin Garden Fountain with Lights and
Planter
WHF2308
Quantity
1
1
Instruction Manual
SAVE THESE INSTRUCTIONS–This manual contains important
safety and operating instructions for power units.