LuxenHome WHF1012 Instruction Manual

Product Name:
SKU #:
Thank you for purchasing this LuxenHöme product. This product has been manufactured with the highest
standards of safety and quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts the packaging inside the carton to ensure there are no missing or damaged parts. If any parts are
missing or damaged, do not attempt to assemble or use the product. Please save the carton for return and/or
storage.
Note: the pump is packaged separately inside the fountain shipping carton. Please check packaging thoroughly.
CARTON CONTENTS:
Description
Fountain
Pump
Compatible Pumps for this fountain:
Pump Model No.
JR350/LED
JB350/LED
YH400/LED
Tools required for assembly: No tools required for assembly.
ASSEMBLY INSTRUCTIONS:
1. Select a flat, level surface for the assembly and final location of your fountain.
2. From the opening at the back of the fountain, insert the water supply tube into the pump outlet. Connect the
pump adapter cord to the LED cord and twist to tighten the connection. Place the pump upright in the back of
the fountain opening.
3. Add clean water into the reservoir. The water level should be approximately 30mm lower than the edge of the
reservoir. Ensure the pump in your fountain is completely submerged in the water.
4. Connect the pump power cord to a ground fault circuit interrupter (GFCI) outlet and the product will begin to
function as intended.
5. Adjust the flow rate (if applicable) to the maximum (+) position. If necessary, readjust the flow rate to the
desired level (remember to always disconnect from the power source before handling the pump).
6. Please do not use the electrical plug during wet weather conditions. Please note: On first use, there may be air
in the pump. It may take several minutes until all the air escapes.
Resin Frog Totem Outdoor Fountain with LED Light
WHF1012
Quantity
1
1
SAVE THESE INSTRUCTIONS–This manual contains important
safety and operating instructions for power units.
Instruction Manual