Advertisement
Quick Links
additional precautions
1. Inspect all parts for shipping damage before
assembly. If there is shipping damage - DO
NOT USE. Contact dealer/carrier for further
instructions.
2. Make certain that the height adjusting snap
buttons fully protrude through the same
respective hole of each leg extension. This
will ensure that the leg extensions are securely
locked in position and an even height is achieved.
3. Ensure ALL screws, nuts and/or bolts are
tightened.
4. Check the rubber tips on the leg extensions
for rips, wear or if they are missing.
Immediately replace any or all if any of these
imperfections exist.
5. All four leg extensions with rubber tips MUST
touch the floor simultaneously at all times.
6. DO NOT stand on chair.
NOTE:
To maintain the beauty of the original finish,
clean with mild soap and rinse with warm water. Wipe
bath seat dry after each use.
adjusting leg height
1. Before use, adjust height of each leg to your
specific needs, making sure all legs are at the same
height. When desired height is reached, lock legs
into place by aligning buttons into proper holes.
NOTE:
Make sure all legs are set to the same height.
2. To be sure legs are locked into place, push down or
pull up on legs.
Rev.4.07.30.14
lifetime limited
warranty
Your Drive branded product is warrantied to be
free of defects in materials and workmanship for
the lifetime of the product for the original con-
sumer purchaser.
This device was built to exacting standards and
carefully inspected prior to shipment. This Lifetime
Limited Warranty is an expression of our confi-
dence in the materials and workmanship of our
products and our assurance to the consumer of
years of dependable service.
This warranty does not cover device failure
due to owner misuse or negligence, or normal
wear and tear. The warranty does not extend to
non-durable
components,
such
accessories, casters, and grips, which are subject
to normal wear and need periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.
© 2014 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China
transfer tub bench
item # 12011KD-1
as
rubber
EU Authorized Representative
Drive Medical LTD
Ainley's Industrial Estate
Elland, West Yorkshire,
United Kingdom HX5 9JP
Advertisement
Related Manuals for Drive 12011KD-1
Summary of Contents for Drive 12011KD-1
- Page 1 Wipe bath seat dry after each use. If you have a question about your Drive device or this warranty, please contact an authorized Drive adjusting leg height dealer.
- Page 2 4. Attach leg with small rubber tip (marked “B”) by 8. Place legs with suction cups into bath tub. depressing brass push pin and inserting into the receptacle with matching “B”. Repeat for second leg (Figure 2). figure 4 Item # 12011KD-1 figure 2 Rev.4.07.30.14...
- Page 3 The warranty does not extend to non-durable components, such as rubber accessories, casters, and grips, which are subject to normal wear and need periodic replacement. If you have a question about your Drive device or this warranty, please contact an authorized Drive dealer. EU Authorized Representative Drive Medical LTD Ainley’s Industrial Estate...
- Page 4 5. Turn transfer bench right-side-up. Attach armrest 7. Insert backrest into base by depressing push pins assembly instructions by depressing brass push pins and sliding into the arm and sliding support tubes through both receptacles. receptacle on the side of the bench. Make sure the Note: Backrest must go through both sets of Weight Capacity: 400 lbs (181 Kg) arm arcs outward, not inward (Figure 3).
Need help?
Do you have a question about the 12011KD-1 and is the answer not in the manual?
Questions and answers