Jupio JBG-N003 Instructions

Jupio JBG-N003 Instructions
Thank you for buying this Jupio product!
To ensure proper operation, read this manual thoroughly before using this
product. After reading, be sure to keep it where it can be seen by all those
who use the product. The D3100 takes one or two EN-EL14 batteries only,
especially suitable for shooting in a large quantity or low temperatures
environment. It is also possible to operate the battery grip using 6 pcs of AA
batteries in the AA batteries holder. lt features a vertical-grip shutter –release
button to enable shooting in the same fashion as a horizontal grip.
◆ Attaching to the camera
1. Remove the battery from the camera.
2. Pull out the camera's battery compartment cover a slanted angle to
detach.(Fig.2) Perform the operation an a table so as not to drop the
camera.
3. Insert the detached cover into its storage slot the ensure that it will not be
lost. when taking out the cover, press lightly on the cover hinge and pull it
out upward at a slanted angel.
4. Remove the protective cover, and then insert the electrical contacts into
the camera battery compartment.(Fig.3)
5. Align the attachment screw with the camera's tripod socket. and then
turn the attach/detach knob to tighten securely.(Fig.4)
＊ Do not further push open the battery compartment cover when it is
already open, Doing so may damage its hinge.
＊ Be sure to attach the battery grip to the camera before inserting the
batteries. The results of the battery check may not be displayed properly
if you attach the battery grip to the camera with the batteries already
inside.
＊ Before removing the battery grip from the camera. be sure to turn the
camera's power switch to <OFF>,and take out the batteries. After re-
moving the batteries, attach the protective cover to the electrical contacts.
◆ Use the EN-EL14 Battery Packs
1.Tweak battery chamber latch, open battery Chamber Cover.(Fig.5)
2.Insert the battery grip electrical contacts to camera's battery chamber and
align the attachment.(Fig.6-①)（D/Fig.6-②)
3. Screw with the camera's tripod socket, then turn the attach/detach knob to
tighten securely.
4.After the installation is completed ,turn on the camera, and make sure that
the camera's LCD displays the figures.
5.To dispatch the battery grip, reverse the above steps.(Fig.7)
◆ Caution
※ The battery grip is not waterproof
※ Never attempt to disassemble or repair the product yourself. The battery
grip warranty does not cover any malfunction resulted from such actions.
※ Make sure that the battery is turned OFF when attaching the battery grip.
Batteries must be inserted accordingly(refer to the polarity guide[+][-]
shown),but, Remove the battery, must be.
Closed Camera
※ Remove the batteries from the battery grip when the camera is not to be
used for an extended period.
※ Do not short-circuit the battery grip with batteries installed.
※ Do not carry or store the battery grip with batteries installed together with
metallic objects.
Battery Status
Check the batteries capacity provided on the camera's
LCD panel
Low Normal
Temperature
temperature 0℃ temperature 20℃
Shooting Two EN-EL14 battery
Appro.3500 Appro.2000
condition NO flash use
Two EN-EL14 battery
Appro.1 800 Appro.1 5 00
50% flash use
When using AA batteries the number of photos which can be taken are
drastically reduced. It always better to using EN-EL14 batteries.
All data are based on manufacturer's standard test result. We apologize for
any mistakes or misprints in the manual, Design and
specifications are subject to change without notice.
Jupio Europe b.v.
Wasaweg 27
9723 JD Groningen
The Netherlands
www.jupio.com