Welcome Page Displays Instead Of Router Main Menu; Troubleshooting With The Leds - NETGEAR DGN2200-100NAS User Manual

If the ADSL link LED is lit, a link has been established to the connected device. If a LAN port
is connected to a 100 Mbps device, verify that the port's LED is green. If the port is 10 Mbps,
the LED is amber.
If any of these conditions does not occur, refer to the appropriate following section.

Welcome Page Displays instead of Router Main Menu

This situation can occur if the CD Setup Wizard does not complete successfully; the unit will stay
in "Wizard Mode". If the "Welcome" page displays instead of the main menu when you try to go
to the Internet or log into the wireless-N modem router, you can bypass the wizard using one of the
following methods:
• Log into the wireless-N modem router at http://routerlogin.com/basicsetting.htm.
• Perform a factory reset to take the router out of "Wizard Mode" altogether.

Troubleshooting with the LEDs

After you turn on power to the wireless-N modem router, the following sequence of events should
occur:
1. When power is first applied, verify that the Power LED
2. After approximately 10 seconds, verify that:
• The Power LED is green.
• The LAN port LEDs are lit for any local ports that are connected. If a LAN port is
connected to a 100 Mbps device, verify that the port's LED is green. If the port is 10
Mbps, the LED will be amber.
• The ADSL link LED is lit, indicating that a link has been established to the connected
device.
• The Wireless LEDs are lit.
Troubleshooting
Wireless-N 300 Modem Router DGN2200 User Manual
v1.0, March 2010
is on.
7-2