Troubleshooting Access To The Router Main Menu - NETGEAR MBRN3000 User Manual

If any of these conditions does not occur, refer to the following table.
Table 11. Troubleshooting with the LEDs
LED
Power LED is off.
Power LED is red
Internet LED is red.
LAN LEDs are off.
Internet LED is blinking red and
green

Troubleshooting Access to the Router Main Menu

If you are unable to access the router main menu from a computer on your local network,
check the following:
If you are using an Ethernet-connected computer, check the Ethernet connection
•
between the computer and the router as described in the previous section.
58 | Chapter 6: Troubleshooting
Mobile Broadband Wireless-N Router MBRN3000
Action
Make sure that the power cord is properly connected to your
•
router and that the power supply adapter is properly connected
to a functioning power outlet.
Check that you are using the power adapter supplied by
•
NETGEAR for this product.
If the error persists, you have a hardware problem and should
•
contact technical support.
There is a fault within the router. Try to clear the fault as follows:
Cycle the power to see if the router recovers.
•
Clear the router's configuration to factory defaults. This sets the
•
router's IP address to 192.168.0.1. This procedure is explained
in
"Restoring the Default Configuration and Password"
page 62.
If the error persists, you might have a hardware problem and should
contact technical support.
The router cannot connect to the Internet.
Make sure the USB LED is lit, indicating that the wireless modem
•
is securely connected to the router.
Your wireless modem must be activated and there must be
•
coverage in your area. To test coverage, connect your modem to
your PC, and try to connect to the Internet directly from your
computer.
Check the NETGEAR website to ensure that your wireless
•
modem is supported.
Close the 3G Connection manager if it is running on your PC.
•
If these LEDs do not light when the Ethernet connection is made,
check the following:
Make sure that the Ethernet cable connections are secure at the
•
router and at the hub or workstation.
Make sure that power is turned on to the connected hub or
•
workstation.
The traffic meter feature is enabled and the limit set has been
reached.
on