1. Manuals
  2. Brands
  3. peerless-AV Manuals
  4. Racks & Stands
  5. PLCK-UNL
  6. Installation and assembly manual

peerless-AV PLCK-UNL Installation And Assembly Manual

Flat panel conversion kit for up to 50" lcd and plasma screens
Hide thumbs Also See for PLCK-UNL:
1
2
3
4
5
6
7
8
9

Advertisement

Table of Contents

Installation and Assembly: Flat Panel Conversion Kit For
up to 50" LCD and Plasma Screens
Models: PLCK-UNL, PLCK-1
Read instruction sheet before you start installation and assembly.
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, for US
customers please call Peerless customer care at 1-800-865-2112, for all international customers, please contact
your local distributor.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
• Never exceed the Maximum Load Capacity.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws fi rmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
• This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal
injury.
Table of Contents
Parts List.................................................................................................................................................................................2
Attaching Extension Column To Ceiling Plate Or Existing Extension Column ........................................................................3
Attaching Ceiling Arm Box to Extension Column ....................................................................................................................4
PLCK-1 Installation .................................................................................................................................................................5
PLCK-UNL Installation ........................................................................................................................................................ 6-8
Visit the Peerless Web Site at www.peerless-av.com
Maximum Load Capacity: 125 lb (57 kg)
WARNING
1 of 9
ISSUED:02-22-07
SHEET #: 202-9197-5 (2013-10-01)
For customer care call 708-865-2112.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PLCK-UNL and is the answer not in the manual?

Questions and answers

Related Manuals for peerless-AV PLCK-UNL

Summary of Contents for peerless-AV PLCK-UNL

  • Page 1 Attaching Extension Column To Ceiling Plate Or Existing Extension Column ................3 Attaching Ceiling Arm Box to Extension Column ........................4 PLCK-1 Installation .................................5 PLCK-UNL Installation ................................ 6-8 1 of 9 ISSUED:02-22-07 SHEET #: 202-9197-5 (2013-10-01) Visit the Peerless Web Site at www.peerless-av.com For customer care call 708-865-2112.

  • Page 2: Parts List

    560-9646 560-9646 #10-32 x 3/16" slotted set screw 520-1187 520-1187 Security Adapter Bracket Fasteners for PLCK-UNL M5 x 12 mm (4) M5 x 25 mm (4) M6 x 12 mm (4) M6 x 25 mm (4) M8 x 12 mm (4)
  • Page 3 Ceiling plate L or M extension column (not supplied) (not supplied) Small Hole slot L or M retaining collar Slot slot 3 of 9 ISSUED:02-22-07 SHEET #: 202-9197-5 (2013-10-01) Visit the Peerless Web Site at www.peerless-av.com For customer care call 708-865-2112.

  • Page 4: Rear View

    Insert one M5 x 10 mm penta-pin screw (E) through the tab on the back of ceiling arm box (A) as shown in rear view. Use the M5 penta-pin tool (I) to tighten screws. Rear View fi g. 3.1 4 of 9 ISSUED:02-22-07 SHEET #: 202-9197-5 (2013-10-01) Visit the Peerless Web Site at www.peerless-av.com For customer care call 708-865-2112.

  • Page 5: Lcd Screen

    Attaching Tilt Bracket to Plasma Or LCD Screen For PLCK-1 Note: Skip to page 6 for PLCK-UNL installation. Note: Refer to adapter plate instruction sheet (sold separately) for attachment of adapter plate to plasma or LCD screen before proceeding with step 4. Note: Screen and adapter plate may appear different than illustrated.
  • Page 6 NOTE: For fl at back screens proceed to step 4-1. For bump-out or recessed back screen skip to step 4-2 6 of 9 ISSUED:02-22-07 SHEET #: 202-9197-5 (2013-10-01) Visit the Peerless Web Site at www.peerless-av.com For customer care call 708-865-2112.
  • Page 7 Repeat for remaining mounting holes, level brackets and tighten screws. SCREEN MULTI-WASHER SPACER SCREW ADAPTER BRACKET (BB) If you have any questions, please call Peerless customer care at 1-800-865-2112. 7 of 9 ISSUED:02-22-07 SHEET #: 202-9197-5 (2013-10-01) Visit the Peerless Web Site at www.peerless-av.com For customer care call 708-865-2112.
  • Page 8 Attaching Tilt Bracket to Adapter Plate for PLCK-UNL Attach tilt bracket (B) to adapter plate (AA) using four Hang tilt bracket (B) onto ceiling arm box (A). Adjust M10 x 15 mm penta-pin screws (G) as shown below. tilt as desired and tighten four M10 x 15 mm penta- Tighten screws using M10 penta-pin tool (H).

  • Page 9: Limited Five-Year Warranty

    This warranty gives specifi c legal rights, and you may also have other rights which vary from state to state. www.peerless-av.com © 2013 Peerless Industries, Inc. Patented. Utiltiy Patent No. 8,517,322. 9 of 9 ISSUED:02-22-07 SHEET #: 202-9197-5 (2013-10-01) Visit the Peerless Web Site at www.peerless-av.com For customer care call 708-865-2112.

This manual is also suitable for:

Plck-1

Table of Contents