TABLE OF CONTENT Important notices Liability ....................................3 Important addresses and telephone numbers........................4 System data ..................................4 Explanation of the symbols Warnings ....................................5 2.1.1 Warning symbols................................5 Safety instructions Technical information Description ..................................6 Use 7 Application limits.................................8 Components Ventilation unit ..................................9 Operator terminal ................................9 Initial commissioning Installation inspection ...............................10 Switching on ..................................10...
Hoval. Any other use is impermissible. - Performance of work on the unit not described in the- se operating instructions and not expressly approved Intended use by the manufacturer.
The full installation inspection must be carried out by a qualified technician trained by Hoval. CAUTION ... indicates a situation of possible danger DANGER...
TEChnICAL InFOrMATIOn Technical information Air filtration The fresh air goes through two cleaning stages, ensu- Description ring the highest standard. A fine-meshed prefilter (was- hable) at the entry of the unit prevents insects, leaves, etc. from reaching the unit. Before the fresh air leaves the unit, it flows through a high-capacity fine pollen filter Exhaust air (ePM...
Please bear in mind that, especially during the • Operation of all Hoval units connected to the bus (e.g. change of seasons, setting a low target humidity value heating).
Therefore, Hoval recommends reducing the air volumes during the day so that less warm air is brought into the building and increasing the air volumes at night.
Detailed operating instructions are enc- Comfort ventilation unit: losed with your operator terminal and can be downloaded from www.hoval.com. Operator terminal BG02 E Filter cover supply air and extract air filter Rotary knob for setting the max. relative...
InITIAL COMMISSIOnIng Initial commissioning WARNING Please note the installation instructions in this regard Installation inspection Please check the following points: • The HomeVent comfort ventilation unit must be moun- ® ted securely and vibration-free on the wall, ceiling or floor. WARNING With ceiling installation: Beware of falling parts.
Have your HomeVent ventilation unit cleaned ® is at the end of the instructions and can be by Hoval Customer Service or an installer trai- downloaded from www.hoval.com ned by Hoval. • Order new filters when you have replaced the old ones to ensure that you can change...
MAInTEnAnCE Prefilter 4. Clean the filter chamber by hand or with a vacuum cleaner. The prefilter is inside the unit on the fresh air inlet. 5. Slide in the cleaned filter. 6. Reinsert the intermediate cover. 7.2.1 Cleaning interval 7. Insert prefilter cover. The prefilter should be cleaned regularly for hygiene re- asons.
MAInTEnAnCE Spare parts NOTICE Use only genuine Hoval accessories. You will find the ordering addresses on the back page of this manual, and at www.hoval.com Filter Designation Part No. class Supply air filter 55 % 5043 550 Pollen fine cassette filter...
LOgS Logs System log Installer ............................................................................................................................................................................Electrician ............................................................................................................................................................................Hoval customer service (see back page of the instructions) ................................... 4 221 328 / 00...
Need help?
Do you have a question about the HomeVent ERT 250 and is the answer not in the manual?
Questions and answers