Advertisement
Quick Links
Photon 250 Installation &
SaaS Version
This document describes how to get started using the Photon
This document describes how to get started using the Photon 250 with a SaaS DP. The SaaS DP
is a cloud-based instance, hosted by
based instance, hosted by Stellar Cyber for your use on a *.stellarcyber.
domain.
The steps are as follows:
1. Connect power.
2. Connect the Photon 250 to the network.
Connect the Photon 250 to the network.
3. Obtain an installation token from the Stellar Cyber GUI.
Obtain an installation token from the Stellar Cyber GUI.
4. Access the Photon 250 CLI.
5. Change the management port set
Change the management port settings.
6. Apply the installation token in the CLI.
Apply the installation token in the CLI.
Connecting Power
To connect power to the appliance
To connect power to the appliance, have a licensed DC power technician:
1. Connect the included power cable to the DC power source
Connect the included power cable to the DC power source.
2. Connect the cable to the Photon 250.
Connect the cable to the Photon 250.
3. Press the power button.
Connecting to the Network
onnecting to the Network
To connect the Photon 250 to the network:
To connect the Photon 250 to the network:
Installation & Quick Start
Stellar Cyber for your use on a *.stellarcyber.cloud
Stellar Cyber, 2024. All rights reserved.
Quick Start Guide
50 with a SaaS DP. The SaaS DP
September, 2024
Advertisement
Related Manuals for Stellar Cyber Photon 250
Summary of Contents for Stellar Cyber Photon 250
- Page 1 SaaS Version This document describes how to get started using the Photon This document describes how to get started using the Photon 250 with a SaaS DP. The SaaS DP 50 with a SaaS DP. The SaaS DP is a cloud-based instance, hosted by based instance, hosted by Stellar Cyber for your use on a *.stellarcyber.
- Page 2 2. Use ports 4 – 8 to connect to data sources (mirror ports or taps). Obtaining an Installation Token Stellar Cyber uses tokens to authorize and configure the installation of a sensor to be used with a SaaS DP. Tokens point the installed sensor to the correct DP, assign the specified tenant, and authorize the sensor installation.
- Page 3 Photon 250 Installation & Quick Start SSH Access The default management IP address on the appliance is 192.168.1.100/24, and the default gateway IP address is: 192.168.1.1. The default username is aella and the password is changeme. For SSH access to the appliance: ssh -l aella 192.168.1.100...
- Page 4 During installation, the sensor timezone is automatically set to UTC+0. Since the logs for some security products may only include the local time without a timezone, Stellar Cyber strongly recommends that you set the sensor timezone to the same timezone as your security product.
Need help?
Do you have a question about the Photon 250 and is the answer not in the manual?
Questions and answers