Stellar Cyber Photon 160 Installation & Quick Start Manual

Photon 160 Installation & Quick Start Guide
Token-Based Authorization
This document describes how to get started using the Photon 160 with token-based This document describes how to get started using the Photon
authorization. Token-based authorization is performed using a token downloaded from the
managing Stellar Cyber server's Sensor Installation
The steps are as follows:
 Connect power.
 Connect the Photon
Connect the Photon 160 to the network.
 Obtain an installation token from the Stella
Obtain an installation token from the Stellar Cyber GUI.
 Access the Photon 160
 Change the management port settings.
Change the management port settings.
 Apply the installation token in the CLI.
Apply the installation token in the CLI.
Connecting Power
To connect power to the appliance, have a licensed DC power technician: To connect power to the appliance, have a licensed DC power technician:
1. Connect the included power cable to the DC power Connect the included power cable to the DC power source.
2. Connect the cable to the Photon Connect the cable to the Photon 160.
3. Press the power button. Press the power button.
Connecting to the Network Connecting to the Network
To connect the Photon 160 to the network:
1. Connect the management port ( Connect the management port ( 1) to a network accessible by the DP
2. Use the
Installation & Quick Start Guide Installation & Quick Start Guide
based authorization is performed using a token downloaded from the based authorization is performed using a token downloaded from the
Sensor Installation page.
160 CLI.
to the network:
2.. 6 monitor ports monitor ports to connect to data sources (mirror ports or taps)
 Stellar Cyber, 2024. All rights reserved.
) to a network accessible by the DP.
sources (mirror ports or taps).
September, 2024
based