Stellar Cyber 3000C Quick Start

Table of Contents

Download this manual

July, 2021

Stellar Cyber Quick Start for the

3000C & 6000C Appliances

To start using Stellar Cyber:

1. Access the 3000C or 6000C appliance

2. Change the management configuration

3. Change the data port configuration

4. Set the license

5. Access the Stellar Cyber GUI

Accessing the 3000C or 6000C Appliance

The procedures for the 3000C and 6000C appliances are identical. You can access the appliance

by VGA console or using SSH.

Sensor ports are available only on the model 3000C and model 6000C POC appliance.

Connect the power supplies at the rear of the appliance in addition to any peripherals used to

access the device (see below). Then, press the power button on the front of the appliance to

power it on.

For VGA console access connect a display device to the system using one of the two VGA ports

(one is in the front and the other is in the rear).

Table of Contents

Do you have a question about the 3000C and is the answer not in the manual?

Page 1 5. Access the Stellar Cyber GUI Accessing the 3000C or 6000C Appliance The procedures for the 3000C and 6000C appliances are identical. You can access the appliance by VGA console or using SSH. Sensor ports are available only on the model 3000C and model 6000C POC appliance.
Page 2 Stellar Cyber Quick Start for the 3000C & 6000C SSH Access The default management IP address on the appliance is 192.168.1.100/24, and the default gateway IP address is: 192.168.1.1. The default User and Password are both: stellar. For SSH access to the appliance: ssh -l stellar 192.168.1.100...
Page 3 Stellar Cyber Quick Start for the 6000C 3000C & inet6 addr: fe80::250:56ff:feb4:f45a/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:34739 errors:0 dropped:458 overruns:0 frame:0 TX packets:8 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:2433623 (2.4 MB) TX bytes:648 (648.0 B)
Page 4 From the console or an SSH session: set otp <string> Accessing Stellar Cyber To log in to the Stellar Cyber GUI, use Chrome or Firefox (the default User is admin, and the default Password is changeme): https://<new management IP address>...

6000c