FUTABA 8FG Instruction Manual page 62

THR CUT
The action is not functional at high throttle to
the setup screen shown below by touching the
RTN button.
and return to the Linkage
menu by touching the
RTN button.
1. Activate the function:
Move the cursor to the [ACT] item and touch
the RTN button to switch to the data input
mode.
Select the ACT mode by scrolling the touch
sensor.
*The display blinks.
Touch the RTN button to activate the
function and return to the cursor mode.
2. Switch selection:
Move the cursor to the [SW] item and access
the switch setup screen by touching the
RTN button and select the switch and ON
direction.
3. Throttle cut position setting:
Move the cursor to the [POS] item and touch
the RTN button to switch to the data input
mode.
Adjust the servo operation position at throttle
cut operation by scrolling the touch sensor.
62
Stops the engine safely and easily.(airplane and helicopter only)
Touch the RTN button to end the adjustment
and return to the cursor mode.
<SensorTouch™>
tight or unreasonable force is not applied to the servo.
Scrolling