FUTABA 12FG Instruction Manual page 66

Mixing rate setting procedure
The HR-3 is taken as an example to describe
mixing rate setting. Mixing applied in other swash
modes is different, but the setting procedure is the
same.
*Set the throttle stick to the preset neutral point. Adjust the
length of the linkage rod so that the swash plate is horizontal
at this position.
*The sub trim function can be used to make small
adjustments.
*Adjust so that the pitch curve is a straight line and pitch
operation is maximum.
*When making the following setting, use the EDIT dial to
move the cursor to the item you want to set and push the
EDIT button to switch to the data input mode. Push the
EDIT button to end adjustment and return to the cursol
move mode.
*Adjust by turning the EDIT dial to the left or right.
*The left and right sides can be adjusted individually.
*Adjust by turning the EDIT dial to the left and right.
*The up and down sides can be adjusted individually.
*Adjust by turning the EDIT dial to the left and right.
*The slow and high sides can be adjusted individually.
Linkage compensation setting procedure
*Perform linkage compensation setting after mixing rate
setting.
*Linkage compensation compensates for interference by
aileron operation with the elevator or elevator operation
with the aileron at collective pitch control for Low pitch and
Hi pitch.
66
<Functions of Linkage Menu>
*When making the following setting, use the EDIT dial to
move the cursor to the item you want to set and push the
EDIT button to switch to the data input mode. Push the
EDIT button to end adjustment and return to the cursol
move mode.
*Adjust the EDIT dial to the left and right.
*The left and right sides can be adjusted individually.
*When the interference increases when the compensation
amount was increased, make adjustments with the
compensation direction [DIR] as "-".
Speed compensation setting procedure
*Adjust by turning the EDIT dial to the left and right.