Changing The Tablet Underlay; Creating A New Tablet Underlay - Wacom GRAPHIRE BLUETOOTH User Manual

Changing the tablet underlay

Some configurations of the tablet come with a printed underlay that can be seen through the transparent
photo frame. You can replace the underlay with a favorite photo or design of your own by following these
steps:
1. To remove the photo frame, slide the two
photo frame locks located on each side of the
tablet to the unlocked position (toward the top
of the tablet). Then grasp the upper edges of
the photo frame with your finger tips and lift
the photo frame away from the tablet.
2. Lift away the printed underlay and replace it
with a new photo or design of your choosing.
3. To replace the photo frame, insert the tabs
located on the lower edge of the cover into
the slots on the tablet. Then lower the photo
frame into place and slide the photo frame
locks to the locked position (towards the
bottom of the tablet). This will protect your
photo or design as you work on the tablet.
To create a new tablet underlay, follow the tips in
the next section.

Creating a new tablet underlay

If you would like to create an image that you can use for the tablet underlay, you can use the templates
provided on the Wacom Pen Tablet Driver CD as a starting point:
1. Insert the Wacom Pen Tablet Driver CD into your computer and locate the T
2. Open the folder to access the template files. Template files come in various formats that can be modified
within any graphics application that supports .jpg or .psd formatted files.
3. Choose one of the pre-designed or blank templates. Then modify it to create your own design.
4. When you are done, print out your new tablet underlay. Use photo-quality paper for best results.
5. Trim the new underlay to size and place it beneath the tablet photo frame. See above.
C I
ONTENTS
NDEX
C I
ONTENTS NDEX
W G
ORKING WITH RAPHIRE
26
Photo frame lock
(one on each side).
folder.
EMPLATES
26