Installing Dti-520 On A Mount Arm - Wacom DTI-520 User Manual

Component Functions

Installing DTI-520 on a Mount Arm

This product conforms to the Video Electronics Standard Association's (VESA) Flat Panel
Monitor Physical Mounting Interface Standard (FPMPMI).
This product can be removed from the stand and mounted on such apparatuses as a
VESA-standard mount arm. In order to do this, M4/0.7 mm screws, which are not included
with the product, are needed. Use screws that will, at the time of installation, penetrate the
surface of the product by no more than 15 mm. Use of longer screws may result in damage
to internal parts of the product.
1
Make sure that both your computer and the product are turned off and that all cables are
disconnected.
2
Place the display unit face down on a flat
surface. To prevent harm to the front of
the unit, first spread a cloth or other similar
material on the flat surface.
3
Remove the four screws that hold the stand
to the unit.
4
Using four M4/0.7 mm screws, securely
mount the arm or similar apparatus to the
back of the unit.
Caution
When installing the unit on a mount arm or
other stand, always follow the directions in
the instruction booklet for the mount arm or
stand, as well as the instructions contained
in this document. Incorrect installation may
result in the product coming loose and falling
and possibly causing product failure.
5
Connect the cables and save the screws
that you removed in step 3.

UM-0314(A)_EN.indd 8
Unscrew
2007/11/12 16:53:12