Running The Rf Link Test With Telnet - Intel 2011B - PRO/Wireless LAN Enterprise Access Point Configuration Manual

Local Access Point
Remote Device MAC Address:
Signal
Quality
Figure 6-6: Test Screen Showing Maximum Quality of 31
Some settings on the RF Configuration screen may also affect the RF Link Test. These settings are
described in 6.6.2: Procedure for Aligning Directional Antennas.
Local Access Point
MAC Addr: 00:A0:F8:93:C5:B5
Figure 6-7: Basic Setup for RF Link Test

6.4.1 Running the RF Link Test with Telnet

For access point networks that are already installed, it may be more appropriate to run the RF Link
Test using a Telnet connection. In this case, you must connect the local access point and computer
running the RF Link Test to the same Ethernet network.
Configuring Access Point Bridging and Repeating (WLAP Mode)
Connection Quality Test
max |
|
|
|
|
|
|
|
|
min |
-------------------------------------------
Tx Rate 11 Mb/s
Rx Rate 11 Mb/s
Wireless AP Link
Portable Computer
Running the RF Link Test
00:A0:F8:94:C2:04
Tx Retries
RSSI
Exit-[ESC]
Remote Access Point
MAC Addr: 00:A0:F8:94:C2:04
Chapter 6. RF Link Test
0
31
LAPTOPLITE2.CDR,
AP11MB3DSHADED.CDR
27