Verifying Your Installation - Cisco 1811W - Integrated Services Router Wireless Quick Start Manual

• 9600 baud
• 8 data bits
• No parity bits
• 1 stop bit
The Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide describes how to configure the router
by using Cisco IOS software.
Follow these steps to connect the router to a terminal or PC:
Connect the RJ-45 end of the console cable to the CONSOLE port on the back panel of the router, as shown in Figure 4.
Step 1
Figure 4 Connecting the Console Cable to the Router
To PC
or Terminal 1
Connect the DB-9 end of the console cable to the console port (also called the serial port) on your PC. If this adapter
Step 2
does not fit your PC console port, you must provide an adapter that fits.
8

Verifying Your Installation

You can verify that you have correctly installed your router by checking the LEDs as described in Table 1.
Table 1 LEDs That Verify Installation
LED Meaning
SYS OK Steady green—Router has successfully booted up and the software is functional.
Blinking green—Router is booting or in ROM monitor mode.
1
POE Off—Inline power supply not installed.
Steady green—Inline power supply OK.
Amber—Power denied.
FE 0–9 Steady green—Ethernet link is established.
Blinking green—Activity on the Ethernet link.
Off—No link.
2
CD Steady green—Modem connection established (carrier detect).
Off—No connection established.
2
SPD Steady green—Connection at high speed (V.90).
Off—Connection at low speed (V.32/V.32b/V.34).
2
BUSY Blinking green—Activity over modem line.
Off—No activity.
7