Connecting The Router - Cisco 1811W - Integrated Services Router Wireless Quick Start Manual

• One CD-ROM containing Cisco Router and Security Device Manager (SDM)
• One antenna kit (optional)
Items You Need to Provide
Depending on your network environment, you may need to provide some of the following items so that you can install the
router:
• Straight-through Ethernet cables (RJ-45-to-RJ-45) to connect the router to a broadband (xDSL or cable) modem and to a
hub or switch
• Ethernet hub or switch to connect the router to the local network, or an xDSL or cable modem to connect the router to the
service provider
• Server or other computer with a network interface card (NIC) or other networked device (such as a hub or a switch) to
connect to the integrated 8-port 10/100-Mbps Ethernet switch
4

Connecting the Router

Figure 2 shows a typical installation of a Cisco 1811 or Cisco 1812 router.
Figure 2 Typical Installation of a Cisco 1811 or Cisco 1812 Router
2
Ethernet Hub
PC
Follow these steps to connect the router to the power supply, your local network, and your service provider network:
Step 1 Connect power to the router as shown in Figure 2:
a. Connect the separate power cord to the power socket on the back panel of the router.
4
1
3
DSL/Cable Modem
5
Internet Service
4 Provider