Table of Contents
Advertisement
Removing the camera
1
Turn off the circuit breaker and power.
2
Remove the cable cover.
Remove the screw (M3) for the cable cover used to secure the cover.
Push the tab parts of the cover to disengage the cover.
3
Disconnect the cables.
Disconnect the power cable, video cable, and control cable, etc.
4
Remove the main unit mounting screw used to secure the unit and mount bracket.
5
Push the unit (). Turn it approximately 20 degrees away from the installed position (),
and remove it ().
Main unit mounting
screw (M3 screw)
(with flat washer, spring
washer)
Note
Do not do this work while holding the camera head since doing so may result in malfunctioning of the unit.
6
Disengage the drop-prevention wire from the mount bracket.
Pull the drop-
prevention wire in the
direction shown by the
arrow above.
14
Twist the wire, and
remove the wire loop
through the opening in
the hook.
Pull the wire in the
direction shown by the
arrow above, and simply
pull it out.
Approx.
20°
Hide quick links:
Advertisement
Table of Contents
