Parts And Their Functions; Camera Unit - Panasonic AW-HE120K Operating Instructions Manual

Parts and their functions

 Camera unit 
<Rear panel>
<Bottom panel>
 Mount bracket for installation surface
(supplied accessory)
Mount this bracket onto the installation surface, and then
attach the camera main unit to the bracket.
 Drop-prevention wire
This wire is screwed down to the bottom panel of the
camera main unit. Loop the circle part of the wire around
the hook of the mount bracket.
 Hole for securing the camera pedestal
This hole is provided in the bottom panel of the camera
pedestal.
 Wireless remote control signal light-sensing
area
The light-sensing area is provided in three places, on the
front panel of the camera pedestal and at the top of the
rear panel.
 Status display lamp
This lights in the following way depending on the status of
the unit.
Orange: When the standby status is established
Green: When the power is on
Red: When trouble has occurred in the unit
Green and blinks twice:
When a signal matched by the remote control
ID has been received from the wireless remote
control (optional accessory) while the power is
on
Orange and blinks twice:
When a signal which is not matched by the
remote control ID has been received from the
wireless remote control (optional accessory)
while the power is on
 Camera head
This rotates in the up and down direction.
 Tilt head
This rotates in the right and left direction.
 Tally lamp
This comes on or goes off in response to the control from
the controller but only when "On" has been selected as the
tally lamp use setting.
 RS-422 connector [RS-422]
This RS-422 connector (RJ45) is connected when
exercising serial control over the unit from an external
device. Use a cable with the following specifications for the
connection to this connector.
The tally lamp can be lit by shorting the TALLY signal
(pin 2) with GND (pin 1).
 Do not apply a voltage to the TALLY signal pin.
LAN cable* (category 5 or above, straight cable),
max. 1000 meters [3280 ft]
*: Use of an STP (shielded twisted pair) cable is
recommended.
Pin No. Signal name Pin No. Signal name
1
2
3
4
GND 5 TXD+
TALLY 6 RXD+
RXD– 7 —
TXD– 8 —
35