Victor CDU20 Operating Manual

O P E R ATI NG MAN UAL
EUTECTIC PLATE CHILLED DISPLAY UNIT
MODEL NUMBERS
CDU20 • CDU30
Thank you for buying a Victor Unit. We hope and expect that
you will get many years of satisfactory use from your purchase.
In order to achieve the best results from your equipment please
read, and follow, the installation, operating, cleaning and
maintenance instructions below. Failure to follow them may
affect the warranty.
1. UNPACKING AND ASSEMBLY
All protective coating used on stainless steel surfaces of the hot
cupboard must be removed. The exposed surfaces can then be
wiped clean with a damp cloth, using a mild detergent or soap
if necessary.
Do not use any abrasive material or form of bleach for cleaning
purposes. Please see cleaning section of these instructions.
2. INSTALLATION
The appliance is fitted with a 13 Amp fused plug and only
requires connection to a suitable 13 Amp socket outlet. This
model is suitable for 230 - 240V A.C. supply only.
Ensure that the electricity supply is as stated on the model's
data plate.
Important:
Wires in the mains lead are coloured in accordance with the
following code:
Green and Yellow (Earth) • Blue (Neutral)) • Brown (Live)
Warning: This appliance must be earthed, do not touch internal
wiring.
As the colours of the wires in the mains lead on this appliance
may not correspond with the coloured markings identifying
the terminals in your plug, proceed as follows:
(a) The wire which is coloured green and yellow must be
connected to the terminal in the plug, which is marked with
letter E or the symbol .
(b) The wire which is coloured blue must be connected to the
terminal which is marked with the letter N or is coloured black.
(c) The wire which is coloured brown must be connected to the
terminal which is marked with the letter L or is coloured red.
FITTING THE SNEEZE SCREEN
The sneeze screen is removed from the unit prior to dispatch to
eliminate breakage during transit. Please see the following
procedure:
(a) Push the glass up behind the top glass support (1).
(b) Hinge the glass behind the lower glass support (2).
(c) Slide the glass into the lower glass support (3).
(d) The glass may be removed for cleaning by reversing the
above process.
3
1
2
3. USE AND BEST PERFORMANCE
The display relies entirely on eutectic plates to chill the
produce; there is not a refrigeration system within the
appliance. The gantry is operated by the rocker switch on the
rear of the appliance.
To obtain the best performance, the following procedure is
suggested:
(a) Eutectic plates should be placed into a freezer for 12 – 24
hours prior to use.
(b) Place the eutectic plates into the bottom of the well
approximately 15 minutes before loading.
(c) All produce placed into the well should be chilled prior to
loading.
(d) After service remove and clean the eutectic plates and
refreeze.
Warning: Do not use eutectic plates that show signs of damage
or leakage.
GANTRY
The gantry will be fitted with a fluorescent tube, this is
controlled by an on/off switch (Ice cooled models do not have
a switch, simply plug the unit into a suitable 13 amp socket) on
the rear of the appliance, which enables the lamp to be
switched on or off. The lamp is replaceable. Please follow the
following procedure:
Replacing Fluorescent Lamp:
(a) Turn off power to the unit. If the bulb has just failed it may
be HOT.
(b) Grip the bulb at both ends, near the connectors and twist
the bulb approximately 90o Degrees.
(c) Gently pull the bulb out of the connectors.
(d) Reverse this process to fit, ensuring that the bulb is held
firmly and correctly within the connectors before releasing.