PacLights FLHQ Series Installation Manual

FLHQ/2
LED Linear High Bay
SAFETY PRECAUTIONS
• Installation should only be performed by individuals with electrical
expertise to prevent potential electrical shock or fire hazards.
• Avoid testing this LED light with any electric generator.
• Ensure installation adheres to local, regional, and national laws and
regulations.
• Always disconnect power before installation or maintenance.
• Proper grounding is essential for safety.
• Avoid installation in hazardous environments. The ambient tempera-
ture should not exceed the maximum rated operating temperature
specified for this product.
• Do not install the product during rain to prevent the risk of lightning
strikes and other accidents.
• Wear gloves during the installation to prevent injuries.
PREPARATION
1. Unpack the fixture. Examine it for any signs of damage.
2. Detach the plate on the back of fixture to access wires.
WIRING
Verify voltage of AC supply before connect. Separate and cap the 0/1-10V dim-
ming wires, if opt not to utilize the dimming function. (Figure 2)
VIOLET
( DIM + )
0-10v DIMMING
BLACK (HOT)
WHITE (NEUTRAL)
INPUT
GREEN (GROUND)
FIG.2
Need help? (800) 988 -6386 Email: CS@PacLights.com Website: www.PacLights.com
Instructions and specifications are subject to change at any time without notice. Copyright© 2025 PacLights All Rights Reserved
PINK
( DIM - )
12v AUX
RED (LOAD/LED +)
LED
OUTPUT
BLUE (LOAD/LED -)
DRIVER
INSTALLATION GUIDE
IMPORTANT
INSTALLATION NOTE
• Confirm that the supply voltage corresponds with the voltage range
specified on the product label.
• Use only wires that meet UL standards or applicable local require-
ments. For voltages AC120-277V, use wires of at least 16 AWG; for
AC220-480V, use wires of at least 18 AWG.
• Ensure the use of a listed waterproof strain relief bushing when con-
necting the power supply cord to an outlet box.
• Do not drill into the fixture unless specifically instructed to do so in the
installation guide. Apply silicone sealant to all wire connectors and any
openings that are drilled into the fixture to ensure a waterproof seal.
• This product supports only passive dimmers with a 0-10V interface.
• In case of any visible smoke or sparking from the wire, immediately
disconnect the power and alert the appropriate personnel.
SELECT WATTAGE / COLOR / BEAM
All models are wattage, color (CCT) and beam angle selectable, adjust with the
dip switches on the back of the fixture. (Figure 1)
FIG.1
PL_INST_FLHQ2-v1
Page 1 of 3