READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
PacLights fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for safety.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR
WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNINGS:
•
Make certain power is OFF before installing or maintaining fi xture. No user serviceable parts inside.
•
To prevent wiring damage or abrasion, do not expose wiring to edges of sharp objects.
CAUTION:
•
For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened fi rmly. Apply weatherproof silicone
sealant around the edge of the Back Box and/or Junction Box. This is especially important with an uneven wall surface. Silicone all plugs and
unused conduit entries.
FCPC SURFACE/CEILING MOUNT
CPC
The F
fi xture can be mounted directly to a Surface/Ceiling. Install the Safety Lanyard with a Screw near the base of the FCPC (Fig. 1). Drill
1
the hole pattern into the Surface/Ceiling to be mounted (Fig. 2). Attached the Lanyard to the Surface/Ceiling. Properly attached the wiring.
Fasten the FCPC fi xture to the Surface/Ceiling (Fig. 3).
LANYARD
SCREW
FIG. 1
WIRING DIAGRAM
Connect the ACL and the ACN from the FCPC Fixture to the conduit with the AC power Supply Cable. Follow the Wiring Diagram provided.
AC POWER SUPPLY
PL_INST_FCPC_v0
FCPC Series LED Canopy Light
FCPC FIXTURE
FIG. 2
HOT [BLACK]
NEUTRAL [WHITE]
GROUND [GREEN]
Need help? (800) 988 -6386 Email: CS@PacLights.com Website: www.PacLights.com
Page 1
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE. PacLights fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.