PacLights FCPG/3 Installation Manual

INSTALLATION GUIDE
SAFETY PRECAUTIONS
• Avoid testing this LED light with any electric generator.
• Ensure installation adheres to local, regional, and national laws and
regulations.
• Always disconnect power before installation or maintenance.
• Proper grounding is essential for safety.
DIMMING FUNCTION
• This LED light is equipped with a dimming function.
• The light features three available dimming methods:0-10VDC or 1-10VDC constant current dimming. PWM signal dimming. Resistance-based dim-
ming. (Choose the appropriate dimming method based on your requirements. You may also opt not to utilize the dimming function.)
• Make your selection based on wire connection preferences, desired dimming methods, and the specific LED fixture purchased.
WIRING
Verify input AC voltage before connect. Separate and cap the 0/1-10V dimming
wires if opt not to utilize the dimming function.
BLACK/BROWN (HOT)
WHITE/BLUE (NEUTRAL)
GREEN/YELLOW (GROUND)
GREEN/YELLOW (GROUND)
BLACK/BROWN (HOT)
FCPG/3
VIOLET PINK
( DIM + ) ( DIM - )
0-10v DIMMING
FIXTURE
INPUT
WHITE/BLUE (NEUTRAL)
VIOLET (DIM +)
GRAY/PINK (DIM -)
Instructions and specifications are subject to change at any time without notice. Copyright© 2024 PacLights All Rights Reserved
Parking Garage Light
IMPORTANT
INSTALLATION NOTE
• Installation should only be performed by individuals with electrical
expertise to prevent potential electrical shock or fire hazards.
• Wear gloves during the installation to prevent injuries.
• In case of any visible smoke or sparking from the wire, immediately
disconnect the power and alert the appropriate personnel.
SELECT WATTAGE and/or COLOR
Selected models are wattage and color (CCT) selectable. The dip switches are
located in the fixture, and can be accessed by removing the metal door (rear of
the fixture) of the LED driver compartment. Adjust the settings for wattage (Figure
1) and light color (CCT) (Figure 2) as needed.
SENSOR/CONTROL INSTALLATION
The FCPG is equipped with a sensor/control receptacle. To install the sensor or
control device, first remove the protective cap located at the bottom of the fixture.
This can be done using a Philips screwdriver. Once the cap is removed, gently
screw the sensor/control into the opening, as illustrated in Figure 3.
Need help? (800) 988 -6386 Email: CS@PacLights.com Website: www.PacLights.com
FIG.1
CONTROL/SENSOR
FIG.3
FIG.2
Page 1 of 3