PacLights FFHL/2 Installation Manual

FFHL/2
LED Sports Light
SAFETY PRECAUTIONS
• Installation should only be performed by individuals with electrical
expertise to prevent potential electrical shock or fire hazards.
• Avoid testing this LED light with any electric generator.
• Ensure installation adheres to local, regional, and national laws and
regulations.
• Always disconnect power before installation or maintenance.
• Proper grounding is essential for safety.
• Avoid installation in hazardous environments. The ambient tempera-
ture should not exceed the maximum rated operating temperature
specified for this product.
• Do not install the product during rain to prevent the risk of lightning
strikes and other accidents.
• Wear gloves during the installation to prevent injuries.
WIRING
Verify input AC voltage before connect. Separate and cap the 0/1-10V dimming wires if opt not to utilize the dimming function.
MOUNTING OPTIONS
This fixture has three bracket options. It comes standard with Yoke bracket.
Yoke Mount (Standard)
Knuckle Mount (Optional)
Slipfitter Mount (Optional)
Need help? (800) 988 -6386 Email: CS@PacLights.com Website: www.PacLights.com
Instructions and specifications are subject to change at any time without notice. Copyright© 2025 PacLights All Rights Reserved
INSTALLATION GUIDE
IMPORTANT
INSTALLATION NOTE
• Confirm that the supply voltage corresponds with the voltage range
specified on the product label.
• Use only wires that meet UL standards or applicable local require-
ments. For voltages AC120-277V, use wires of at least 16 AWG; for
AC220-480V, use wires of at least 18 AWG.
• Ensure the use of a listed waterproof strain relief bushing when con-
necting the power supply cord to an outlet box.
• Do not drill into the fixture unless specifically instructed to do so in the
installation guide. Apply silicone sealant to all wire connectors and any
openings that are drilled into the fixture to ensure a waterproof seal.
• This product supports only passive dimmers with a 0-10V interface.
• In case of any visible smoke or sparking from the wire, immediately
disconnect the power and alert the appropriate personnel.
Note: safetly chain or cable (purchased separately)
is strongly recommended for Yoke or Knuckle mount
installations.
Note: for 480v model/setting, con-
nects Black and White to separated
phase.
Page 1 of 5
PL_INST_FFHL2-v1