PacLights FPTA/2 - 055/075 Installation Manual

INSTALLATION GUIDE
FPTA/2 - 055/075
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
PacLights fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for safety.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR
WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNINGS:
• Make certain power is OFF before installing or maintaining fi xture. No user serviceable parts inside.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sharp objects.
CAUTION:
• For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened fi rmly. Apply weatherproof silicone
sealant around the edge of the Back Box and/or Junction Box. This is especially important with an uneven wall surface. Silicone all plugs and
unused conduit entries.
FPTA/2 LIGHT MODULE ANGLE ADJUSTABLE
The FPTA/2 fi xture removed from the box is in a vertical confi guration
(Fig. 1). The FPTA/2 fi xture can be rotated in various angles up to ±90°.
Remove the Screws from each side and rotate the Light Module of the
FPTA/2 fi xture to the desired angle (Fig. 2). Fasten the Screws to secure
the Light Module in place (Fig. 3).
FPTA/2
FIXTURE
FIG. 1 FIG. 2
WIRING DIAGRAM
Connect the ACL and the ACN from the FPTA/2 fi xture to the conduit with the AC power Supply Cable. Follow the Wiring Diagram provided.
AC POWER SUPPLY
HOT [BLACK]
NEUTRAL [WHITE]
GROUND [GREEN]
PL_INST_FPTA/2_v0
FPTA generation 2 Series LED POST TOP LIGHT
IMPORTANT
LIGHT
MODULE
SCREW
FIG. 3
FPTA/2 DRIVER
Need help? (800) 988 -6386 Email: CS@PacLights.com Website: www.PacLights.com
Instructions and specifi cations are subject to change at any time without notice. Copyright© 2022 PacLights All Rights Reserved
FPTA/2 - 150
OPTIONAL PHOTOCONTROL
The Photocontrol has a Dusk to Dawn functionality.
Note: If the Photocontrol is not included the following can be skipped. If
the Photocontrol is included prior to fi eld installation, the following can be
skipped.
All FPTA/2 fi xtures come with a NEMA Three-Prong Twist Lock
receptacle with a Short-Cap pre-installed. Remove the Short-Cap by
twisting CCW and lifting (Fig. 4). Place the Photocontrol on the NEMA
receptacle. Carefully push down and twist CW (Fig. 5).
SHORT CAP
NEMA
RECEPTACLE
FIG. 4
DIM
PHOTOCONTROL
FIG. 5
Page 1 of 2