Epson DM-D110 - Vacuum Fluorescent Display Character Installation Manual page 30

5. When using as a stand alone, go to step 6.
When using with the printer, connect one end of the printer
interface cable for the printer to the printer connector on the DM-D
stand; then connect the other end to the connector on the printer.
Tighten the screws on both ends of the cable to fasten them.
printer
6. When not using the extension cable for power supply packed with
the DM-D stand, go to step 7.
When using the extension cable, connect it (with the arrow mark
up) to the extension cable connector indicated with "POWER OUT"
on the DM-D stand; then connect the other end to the power
connector on the printer.
extension cable
connector
28
extension cable fo
power supply