Commercial Mode Setup - Zenith HCS5650 Installation And Operating Manual

Commercial Mode Setup

Following is the Commercial Mode Operation Setup.
Operating Installer Menu
To set up the controls for the TV you will need to know how to enter the
TV/STB Installer menu and make changes to the default values as required.
If necessary, familiarize yourself with the TV/STB Installer menu and how to
make and save changes in the menu.
Optional Installer Remote
You will need an Installer remote control similar to the one shown to the
right.
The TV's closable features need to be set up before 2-5-5 + Menu is done.
This is a critical step.
If the Master TV display panel's closable features like: Clock Set, adding
channel icons and channel labels, etc. are not done properly, then the
cloned TV/STB will all have problems. For example, do not do 2-5-5 + Menu
more than once or the TV setup will become corrupted.
If you need to start the procedure over, then begin by setting installer item
117 to 001, and pressing Enter to reset the TV to default values in the
installer menu. You can do 2-5-4 + Menu mode more than once but this
mode is limited to only editing channel icons and channel labels.
Refer to the appropriate section in the Manual for other TV features:
Picture, Sound etc.
LT2002 Clone Programmer
As the cloning procedure is being performed, specif-
ic steps need to be done at the indicated times to
achieve the desired result. Be sure to do each
cloning task as indicated.
If a procedure or step is left out or not performed
correctly, then the TV setup will be wrong and
cloning may network. At each step, pay attention to
assure the TV screen shows the proper message(s)
when cloning. If the message indicated does not
¤
appear, there is a problem with that step and
QuickSet II Programmer
LT2002
cloning may not be successful.
Cloning is only possible when the signal source is an
Analog channel, not a digital channel.
HCS5650XX PTC INSTALLER MENU
000 INSTALLER SEQ 000
UPN 000-000-000-000 FPGA 09F1
PTC V1.00.000 CPU V1.01.00
Typical Installer Menu
P A G E 5 3